The influence of patellofemoral stabilisation surgery on joint congruity: an MRI surface mapping study

In the unstable patellofemoral joint (PFJ), the patella will articulate in an abnormal manner, producing an uneven distribution of forces. It is hypothesised that incongruency of the PFJ, even without clinical instability, may lead to degenerative changes. The aim of this study was to record the change in joint contact area of the PFJ after stabilisation surgery using an established and validated MRI mapping technique.

A prospective MRI imaging study of patients with a history of PFJ instability was performed. The patellofemoral joints were imaged with the use of an MRI scan during active movement from 0° through to 40° of flexion. The congruency through measurement of the contact surface area was mapped in 5-mm intervals on axial slices. Post-stabilisation surgery contact area was compared to the pre-surgery contact area.

In all, 26 patients were studied. The cohort included 12 male and 14 female patients with a mean age of 26 (15-43). The greatest mean differences in congruency between pre- and post-stabilised PFJs were observed at 0-10 degrees of flexion (0.54 cm² versus 1.18 cm², p = 0.04) and between 11° and 20° flexion (1.80 cm² versus 3.45 cm²; p = 0.01).

PFJ stabilisation procedures increase joint congruency. If a single axial series is to be obtained on MRI scan to compare the pre- and post-surgery joint congruity, the authors recommend 11° to 20° of tibiofemoral flexion as this was shown to have the greatest difference in contact surface area between pre- and post-operative congruency.