Related Experiment Video
Updated: Nov 4, 2025
Author Spotlight: Three-Dimensional Cephalometric Landmark Annotation Demonstration on Human Cone Beam Computed Tomography Scans
Published on: September 8, 2023
Relationship of natural occlusal plane with different anatomical landmarks
Mehwish Khan1, Syed Murtaza Raza Kazmi2, Farhan Raza Khan3
1Department of Prosthodontics, Sindh Institute of Oral Health Sciences, Jinnah Sindh Medical University, Karachi, Pakistan.
Objective:
To evaluate the parallelism of natural maxillary occlusal plane with inter-pupillary line and ala-tragus line, and to evaluate the anatomic relationship of natural mandibular occlusal plane with retromolar pad among dentate subjects.
Methods:
The cross-sectional study was conducted from September 2017 to February 2018 at Fatima Jinnah Dental College, Karachi, and comprised front and profile photographs of subjects aged 20-28 years while holding the camper's plane against the maxillary occlusal plane. The photographs were imported in a software and an interpupillary line was drawn and the angle with Camper's plane was measured. On both profile pictures, lines were drawn from base of the ala to the superior, middle and inferior points on the tragus. The angle between ala-tragus line and Camper's plane were measured. Intra-orally, height of the mandibular occlusal plane in relation to the retromolar pad was evaluated using a stainless steel scale. Data was analysed using SPSS 23.
Results:
Of the 109 subjects with a mean age of 23.03±1.36 years, 76(69.72%) were females. Horizontal parallelism of occlusal plane with inter-pupillary line was observed with a mean angle of 1.17±1.27 degrees. The angle between the occlusal plane and the inferior ala-tragus line was 4.25 degrees on the right side, and 4.50 degrees on the left. Intraorally, mandibular occlusal plane coincided with the inferior 48(44%) and the middle third 48(44%) of the retromolar pad.
Conclusions:
Inter-pupillary line and retromolar pad area should be used as a guide in the determination of plane of occlusion. The ala-tragus line was not found to be a reliable guide.
Related Concept Videos
01:06Body Planes
The sagittal plane is the plane that divides the body or an organ vertically into right and left sides. If this vertical plane runs directly down the middle of the body resulting in equal division, it is called the midsagittal or median...
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...
01:11Anatomical Positions
The body is upright, facing forward, and standing erect.
The feet are parallel and flat on the floor.
The arms are hanging by the...
01:09Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An...
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
00:51Anatomical Movements
Here are some common anatomical movements:
Flexion and extension motions are in the sagittal (anterior–posterior) plane of motion. These movements take place at the shoulder, hip, elbow, knee, wrist,...