Analyses of Influence on Chromium Coating after Grinding from the View of Final Microstructure and Microhardness in...

The article deals with the analysis of chromium layer grinding on a steel substrate, where this issue was addressed with regard to the requirements of the manufacturing sector, specifically in the aerospace industry. The experimental samples were chromium-plated and ground under different cutting conditions by the grooving method of grinding. Two types of grinding wheels for grinding were used, grinding wheel based on SG (solgel) a grinding wheel based on SiC. The resulting microstructure and microhardness in the machined layer were evaluated with using of confocal laser microscopy, inverted materials microscopy, and hardness testing. Based on the results, recommendations were made regarding a suitable approach to grinding the chromium coating. We used a confocal laser microscope and hardness tester for the evaluation of presented values. It was found that, on the base of analyses values, with both grinding wheel and using cutting conditions used, good results have been achieved. This could be stated, because the analysis of the samples microstructure after grinding for the given cutting conditions showed that it is possible that a small influence is completely acceptable from the point of the final product view and there are no major negative phenomena. Measurements of surface microhardness after grinding showed similar results for all samples. The SiC-based grinding wheel showed slightly better results, but both grinding wheels can be used without problems for the presented cutting conditions, and the presented cutting conditions with both grinding wheels can be recommended for the grinding of the given material.