Influence of commercial adhesive with/without silane on the bond strength of resin-based composite repaired within...

It is not clear whether the ground surface of resin-based composite (RBC) polymerized requires the application of an adhesive with/without a silane to improve bond strength. This study investigated the bond strength of RBC repaired within 24 h via the application of adhesive with/without a silane.

Seventy RBC blocks were prepared and assigned to either 0 or 24 h repair stage. Each stage was divided into seven groups: a control group with no surface roughening or applied adhesive, a surface-roughened group with no applied adhesive, two surface-roughened groups treated with a G-aenial Bond adhesive and a BeautiBond Multi adhesive, two surface-roughened groups treated with the previously-mentioned adhesives as well as silane coupling agents, and one group treated with a Single Bond Universal silane-containing adhesive. Microtensile bond strength (μTBS) measurements were performed after the repaired RBC blocks of each group (n = 5) had been immersed in a 37 °C water bath for 24 h. The failure mode of each sample was determined, and the data were analyzed via one-way analysis of variance and Dunnett's test (p = 0.05).

Regardless of the repair stage, the μTBS values of the adhesive-only and silane-adhesive groups did not differ significantly from those of the control group (p > 0.05). Only the no-adhesive groups exhibited a significantly time-dependent increase in adhesive failure rate.

Our results suggest that the application of adhesives either with or without silane can significantly increase the bond strength of repairs to RBCs polymerized within 24 h.