The part-whole effect in super-recognisers and typical-range-ability controls

Elena Belanova1, Josh P Davis1, Trevor Thompson1

  • 1School of Human Sciences, Institute of Lifecourse Development, University of Greenwich, United Kingdom.

Vision Research
|July 5, 2021
PubMed

Related Concept Videos

Range Rule of Thumb to Interpret Standard Deviation01:13

Range Rule of Thumb to Interpret Standard Deviation

The range rule of thumb in statistics helps us calculate a dataset's minimum and maximum values with known standard deviation. This rule is based on the concept that 95% of all values in a dataset lie within two standard deviations from the mean.
For instance, the range rule of thumb can be used to find the tallest and the shortest student in a class, given the mean student height and standard deviation. If the mean student height is 1.6 m and the standard deviation, s is 0.05 m, the height...
11.2K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
7.5K
The R Chart01:02

The R Chart

In statistical process control, control charts, particularly R charts, are instrumental in monitoring process variations and identifying non-random patterns that run charts might miss. R charts track the variability within process subgroups, which is crucial when standard deviation use is impractical or unknown process variations exist.
R charts are pivotal for pinpointing shifts in process variability. Stability is indicated when all data points remain within the defined upper and lower...
195
Interpreting R Charts01:22

Interpreting R Charts

R chart, or range chart, is a fundamental tool in statistical process control used to monitor the variability within a process. It complements the X-bar (x̄) chart by focusing on the range of the data, rather than individual values, providing a clear picture of the process dispersion over time.
An R chart plots the range of subsets of measurements collected from a process. Each point on the chart represents the range—defined as the difference between the maximum and minimum...
159
Range00:59

Range

The range is one of the measures of variation. It can be defined as the difference between a dataset's highest and lowest values. For example, in the study of seven 16-ounce soda cans, the filled volume of soda was measured, thus producing the following amount (in ounces) of soda:
15.9; 16.1; 15.2; 14.8; 15.8; 15.9; 16.0; 15.5
Measurements of the amount of soda in a 16-ounce can vary since different subjects record these measurements or since the exact amount - 16 ounces of liquid, was not...
13.1K