Related Experiment Video

Updated: Oct 29, 2025

Coupling Carbon Capture from a Power Plant with Semi-automated Open Raceway Ponds for Microalgae Cultivation
08:17

Coupling Carbon Capture from a Power Plant with Semi-automated Open Raceway Ponds for Microalgae Cultivation

Published on: August 14, 2020

5.5K

EU-28's progress toward the 2020 renewable energy share: a club convergence analysis

María José Presno1, Manuel Landajo2

  • 1Department of Applied Economics, University of Oviedo, Avenida del Cristo, s/n, 33011, Oviedo, Asturias, Spain. mpresno@uniovi.es.

Environmental Science and Pollution Research International
|July 8, 2021
PubMed

Keywords:
2020 targetClubs of convergenceEuropean UnionProbit modelRenewable energy shareSectors

More Related Videos

Measurements of CO2 Fluxes at Non-Ideal Eddy Covariance Sites09:05

Measurements of CO2 Fluxes at Non-Ideal Eddy Covariance Sites

Published on: June 24, 2019

8.1K
Implementation of Portable Emissions Measurement Systems PEMS for the Real-driving Emissions RDE Regulation in Europe09:34

Implementation of Portable Emissions Measurement Systems PEMS for the Real-driving Emissions RDE Regulation in Europe

Published on: December 4, 2016

28.4K

Related Concept Videos

Energy Diagrams - II01:10

Energy Diagrams - II

Energy diagrams are important to understand the dynamics of a system. The topology of an energy diagram helps illustrate the equilibrium points of the system.
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...
7.4K
Power and Energy01:12

Power and Energy

The power and energy delivered to an element are subjects of great significance in the field of electrical engineering. It is a well-known fact that a 100-watt light bulb emits more light than a 60-watt one. Therefore, power and energy calculations play a crucial role in the analysis of electrical circuits.
Power, defined as the time rate of expending or absorbing energy, is quantified in units called watts (W). The relation between power and energy is mathematically given as
1.4K
Energy Diagrams - I01:14

Energy Diagrams - I

The dynamics of a mechanical system can be easily understood by interpreting a potential energy diagram. Since energy is a scalar quantity, the interpretation of the dynamics of the system becomes even simpler.
Take the example of a skater on a parabolic ramp. The potential energy at different points along the ramp will be proportional to the height of the ramp, which varies quadratically with the horizontal position on the ramp. As the skater moves down the ramp from the highest position,...
5.2K
Conservation of AC Power01:15

Conservation of AC Power

The principle of power preservation is applicable to both ac and dc circuits. This principle, when applied to AC power, asserts that the complex, real, and reactive powers produced by the source are equal to the total complex, real, and reactive powers absorbed by the loads. When two load impedances are connected in parallel to an ac source V, the complex power provided by the source can be calculated using the relation
437
Maximum Power Transfer01:16

Maximum Power Transfer

Numerous practical applications within engineering disciplines, such as telecommunications, necessitate optimizing power delivery to a connected load. This pursuit, however, entails inherent internal losses, which can either equal or exceed the power supplied to the load. The Thevenin equivalent circuit is helpful in finding the maximum power a linear circuit can deliver to a load. It is assumed in this context that the load resistance can be adjusted.
By substituting the entire circuit with...
538
Energy Conservation and Bernoulli's Equation01:16

Energy Conservation and Bernoulli's Equation

Applying the conservation of energy principle or the work-energy theorem to an incompressible, inviscid fluid in laminar, steady, irrotational flow leads to Bernoulli's equation. It states that the sum of the fluid pressure, potential, and kinetic energy per unit volume is constant along a streamline.
All the terms in the equation have the dimension of energy per unit volume. The kinetic energy per unit volume is called the kinetic energy density, and the potential energy per unit volume is...
9.9K