Related Experiment Video
Updated: Oct 25, 2025

Thermal Scanning Conductometry TSC as a General Method for Studying and Controlling the Phase Behavior of Conductive Physical Gels
Published on: January 23, 2018
Experimental Investigation of the Apparent Thermal Conductivity of Microencapsulated Phase-Change-Material Slurry at
Krzysztof Dutkowski1, Marcin Kruzel1
1Faculty of Mechanical Engineering, Koszalin University of Technology, ul. Raclawicka 15-17, 75-620 Koszalin, Poland.
Abstract:
The article presents the results of detailed studies of the thermal conductivity of the water slurry of microencapsulated PCM (mPCM) and slurry based on water-propylene glycol solutions. The starting product, MICRONAL® 5428 X, which contains about 43% microencapsulated paraffin with a transformation temperature of 28 °C, was mixed with the base liquid to obtain slurries with mass fractions of mPCM of 4.3, 8.6, 12.9, 17.2, 21.5, 25.8, 30.1, 34.4, 38.7, and 43.0%. Detailed measurements were carried out in the temperature range of 10-40 °C. It was found that: (a) an increase in the temperature of the slurry caused an increase in its thermal conductivity, both when PCM was in the form of a solid and a liquid; (b) the thermal conductivity of the mPCM slurry when the PCM was in liquid form was greater than the thermal conductivity of the slurry when the PCM was liquid; (c) during the phase transformation, a significant increase in the thermal conductivity of the slurry was observed, and its peak occurred when the temperature of the slurry reached the temperature declared by the manufacturer at which the phase-transition peak occurs.
More Related Videos
Related Concept Videos
Phase Changes
A substance melts or freezes at a temperature called its melting point and boils or condenses at its boiling point. These temperatures depend on pressure. High pressure favors the denser form of the substance, so typically, high pressure...
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...
Specific Heat
For example, increasing the temperature of one gram of water by 1°C requires one calorie of heat energy and can be written as 1 cal/g-°C, or...
Phase Transitions
Phase Transitions: Sublimation and Deposition

