Metal-organic framework application for mercury speciation using solid phase extraction followed by direct thermal...

Metal-organic frameworks (MOFs) are increasingly used in analytical chemistry for pre-concentration of trace elements followed by their determination using modern analytical techniques. However, there are a limited number of publications concerning the use of MOFs for speciation purposes, while their structural and functional features are perspective for the element species selective extraction and pre-concentration. It is known that mercury refers to the most hazardous elements which species demonstrate different toxicity, migration routes and bioavailability as well. Consequently the development of new approaches for mercury speciation in environments remains an actual objective of analytical chemistry. In present work a new methodology for inorganic and organic mercury speciation in water was proposed. This approach is based on pre-concentration using solid phase extraction (SPE) followed by their determination directly from the solid phase with the application of the thermal release - electrothermal-atomic-absorption technique (TR-ETA-AAS). An original SPE-procedure based on the use of UIO-66 [Zr₆O₄(OH)₄(bdc)₆] in two different modes (non-modified and modified with cysteine) as a sorbent was designed. As a result of SPE as well as TR-ETA-AAS optimization the detection limits (LOD) for all listed species at the level of 0.06 μg L^-1 have been achieved. It was also shown that the presence of the other elements (K, Na, Ca, Mg at the level of 100 μg L^-1, and Mn, Fe, Cr, Al, Zn, Cd, Pb - of 25 μg L^-1) does not affect the results obtained. The developed assay demonstrates a high efficiency, low LODs, wide linear range and admissible analysis duration. The reliability of the data obtained was confirmed by the standard addition approach and by a comparison with the results of independent analytical methods.