Related Experiment Video

Updated: Oct 20, 2025

Evaluation of the Curing of Adhesive Systems by Rheological and Thermal Testing
09:06

Evaluation of the Curing of Adhesive Systems by Rheological and Thermal Testing

Published on: July 3, 2020

7.4K

Thermal and Dielectric Properties of Cyanate Ester Cured Main Chain Rigid-Rod Epoxy Resin

Chi-Ping Li1, Chih-Min Chuang2

  • 1Department of Chemical Engineering, National United University, Miaoli 36063, Taiwan.

Polymers
|September 10, 2021
PubMed

Keywords:
cyanate estersdielectric propertiesepoxy resinliquid crystalthermal properties

More Related Videos

Synthesis of Programmable Main-chain Liquid-crystalline Elastomers Using a Two-stage Thiol-acrylate Reaction11:17

Synthesis of Programmable Main-chain Liquid-crystalline Elastomers Using a Two-stage Thiol-acrylate Reaction

Published on: January 19, 2016

22.3K
Preparation of Monodomain Liquid Crystal Elastomers and Liquid Crystal Elastomer Nanocomposites12:21

Preparation of Monodomain Liquid Crystal Elastomers and Liquid Crystal Elastomer Nanocomposites

Published on: February 6, 2016

13.0K

Related Concept Videos

Physical Properties of Carboxylic Acid Derivatives01:19

Physical Properties of Carboxylic Acid Derivatives

Intermolecular forces dictate several physical properties such as boiling points, melting points, solubilities, and so forth. They are classified into four types: ionic forces, hydrogen bonds, dipole–dipole forces, and dispersion forces. Ionic forces are the strongest, while dispersion forces are the weakest.
Among the carboxylic acid derivatives, the boiling points of acid chlorides and esters are very similar and are the lowest in the series. Acid anhydrides have slightly higher boiling...
2.8K
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
7.6K
Polymer Classification: Crystallinity01:21

Polymer Classification: Crystallinity

Unlike ionic or small covalent molecules, polymers do not form crystalline solids due to the diffusion limitations of their long-chain structures. However, polymers contain microscopic crystalline domains separated by amorphous domains.
Crystalline domains are the regions where polymer chains are aligned in an orderly manner and held together in proximity by intermolecular forces. For example, chains in the crystalline domains of polyethylene and nylon are bound together by van der Waals...
3.4K
Polymer Classification: Architecture01:14

Polymer Classification: Architecture

Polymers are classified as linear or branched on the basis of their chain architecture. The polymer chains in linear polymers have a long chain-like structure with minimal to no branching at all. Even if a polymer features large substituent groups on the monomer, which appear as branches to the skeleton, it is not considered a branched polymer. A branched polymer contains secondary polymer chains that arise from the main polymer chain. The branching occurs when the polymer growth shifts from...
3.3K
Structure and Nomenclature of Epoxides02:38

Structure and Nomenclature of Epoxides

Cyclic ethers are heterocyclic compounds with an oxygen atom in the ring along with carbon atoms. They are named depending on the number of carbon atoms present in their ring system. Cyclic ethers with a three-membered ring system are called “oxirane”, four-membered ring systems as “oxetane”, five-membered ring systems as “oxolane”, and six-membered ring systems as “oxane”. The cyclic structure of these rings imposes angle strain, and this strain...
7.0K
Acid-Catalyzed Ring-Opening of Epoxides02:24

Acid-Catalyzed Ring-Opening of Epoxides

Epoxides that are three-membered ring systems are more reactive than other cyclic and acyclic ethers. The high reactivity of epoxides originates from the strain present in the ring. This ring strain acts as a driving force for epoxides to undergo ring-opening reactions either with halogen acids or weak nucleophiles in the presence of mild acid. The acid catalyst converts the epoxide oxygen, a poor leaving group, into an oxonium ion, a better leaving group, making the reaction feasible. The...
7.8K