Related Experiment Video

Updated: Oct 18, 2025

Combustion Chemistry of Fuels: Quantitative Speciation Data Obtained from an Atmospheric High-temperature Flow Reactor with Coupled Molecular-beam Mass Spectrometer
07:24

Combustion Chemistry of Fuels: Quantitative Speciation Data Obtained from an Atmospheric High-temperature Flow Reactor with Coupled Molecular-beam Mass Spectrometer

Published on: February 19, 2018

10.2K

Structural Insight into La0.5Ca0.5Mn0.5Co0.5O3 Decomposition in the Methane Combustion Process

Olga Nikolaeva1, Aleksandr Kapishnikov1, Evgeny Gerasimov1

  • 1Boreskov Institute of Catalysis SB RAS, 630090 Novosibirsk, Russia.

Nanomaterials (Basel, Switzerland)
|September 28, 2021
PubMed

Keywords:
in situ XRDmicrostructureperovskitephase transformationrecrystallization

More Related Videos

Combustion Characterization and Model Fuel Development for Micro-tubular Flame-assisted Fuel Cells08:16

Combustion Characterization and Model Fuel Development for Micro-tubular Flame-assisted Fuel Cells

Published on: October 2, 2016

9.7K
Identification and Quantification of Decomposition Mechanisms in Lithium-Ion Batteries; Input to Heat Flow Simulation for Modeling Thermal Runaway11:25

Identification and Quantification of Decomposition Mechanisms in Lithium-Ion Batteries; Input to Heat Flow Simulation for Modeling Thermal Runaway

Published on: March 7, 2022

4.8K

Related Concept Videos

Enthalpy and Heat of Reaction02:12

Enthalpy and Heat of Reaction

Combustion, commonly known as burning, is a reaction in which a substance reacts with an oxidizing agent, which in most cases is molecular oxygen, to liberate energy in the form of heat, light, or sound. The heat of combustion is also known as the enthalpy of combustion. The energy released when one mole of a substance undergoes complete combustion at constant pressure is called molar heat of combustion. Combustion reactions are exothermic; that is, they release energy, and their ΔH sign...
9.0K
Limiting Reactant02:27

Limiting Reactant

The relative amounts of reactants and products represented in a balanced chemical equation are often referred to as stoichiometric amounts. However, in reality, the reactants are not always present in the stoichiometric amounts indicated by the balanced equation.
63.7K
Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes02:14

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes

The low reactivity in alkanes can be attributed to the non-polar nature of C–C and C–H σ bonds. Alkanes, therefore, were  initially termed as “paraffins,” derived from the Latin words: parum, meaning “too little,” and affinis, meaning “affinity.”
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
7.1K
Synthesis and Decomposition Reactions02:17

Synthesis and Decomposition Reactions

Synthesis and decomposition are two types of redox reactions. Synthesis means to make something, whereas decomposition means to break something. The reactions are accompanied by chemical and energy changes. 
36.4K
Enthalpies of Reaction03:33

Enthalpies of Reaction

Hess’s law can be used to determine the enthalpy change of any reaction if the corresponding enthalpies of formation of the reactants and products are available. The main reaction may be divided into stepwise reactions : (i) decompositions of the reactants into their component elements, for which the enthalpy changes are proportional to the negative of the enthalpies of formation of the reactants, −ΔHf°(reactants), followed by (ii) re-combinations of the elements (obtained...
35.2K
Mass Spectrum01:23

Mass Spectrum

A mass spectrum is the graphical representation of the relative abundance of the charged fragments in an analyte plotted against their mass-to-charge ratio (m/z). The plot's x axis represents the ratio of the mass of the charged fragment to the elementary charge it carries. The y axis of the plot represents the relative abundance of each charged species. The relative abundance is calculated from the signal intensity of each charged species recorded at the detector. The most intense signal...
2.9K