Related Experiment Video

Updated: Oct 18, 2025

Data Communication Based on MQTT in a Polymer Extrusion Process
08:15

Data Communication Based on MQTT in a Polymer Extrusion Process

Published on: July 15, 2022

3.6K

A case for standardized communications for point of distribution operations

Travis L Cline1, Kar Ee Ho1, Chris Hood1

  • 1Purdue Homeland Security Institute, Purdue University, West Lafayette, Indiana.

Journal of Emergency Management (Weston, Mass.)
|September 28, 2021
PubMed
Abstract

More Related Videos

The Portable Chemical Sterilizer PCS, D-FENS, and D-FEND ALL: Novel Chlorine Dioxide Decontamination Technologies for the Military14:17

The Portable Chemical Sterilizer PCS, D-FENS, and D-FEND ALL: Novel Chlorine Dioxide Decontamination Technologies for the Military

Published on: June 29, 2014

14.7K
Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements09:36

Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements

Published on: June 25, 2021

3.3K

Related Concept Videos

Distribution Reliability and Automation01:25

Distribution Reliability and Automation

Distribution reliability in electrical power systems is critical for ensuring an uninterrupted power supply to consumers at minimal cost. According to IEEE Standard Terms, reliability is the probability that a device will function without failure over a specified time period or amount of usage. For electric power distribution, this translates to maintaining continuous power supply and addressing customer concerns over power outages. Several indices, as defined by IEEE Standard 1366-2012, are...
182
Primary Distribution01:28

Primary Distribution

Primary distribution systems deliver electrical power from substations to consumers through various voltage classes, with 15-kV class voltages being predominant among U.S. utilities. Older 2.5- and 5-kV classes are being replaced by 15-kV primaries, while higher 25- to 34.5-kV classes are used in high-density urban areas and rural regions with long feeders. Three-phase, four-wire multigrounded systems are widely employed for balanced power delivery, using the neutral wire as a grounding point.
172
Types of Reports III: Telephone and Verbal Reports01:26

Types of Reports III: Telephone and Verbal Reports

Telephone and Verbal Reports in healthcare settings are two communication methods for conveying therapeutic instructions from healthcare providers to nurses or other healthcare staff.
Here's an overview of each type:
Telephone Orders
845
Discharge Summary Forms01:31

Discharge Summary Forms

The discharge summary is crucial as it enables a smooth transition from a healthcare facility to a patient's home or another care setting. This critical document facilitates seamless continuity of care, ensuring patients receive the necessary support and attention.
Here's a detailed look at the key components and guidelines for preparing a discharge summary:
986
Secondary Distribution01:25

Secondary Distribution

Secondary distribution systems provide electrical energy at the utilization voltage levels from distribution transformers to customer meters. Typical secondary voltages in the United States include 120/240 V for residential use, 208Y/120 V for residential and commercial use, and 480Y/277 V for industrial and high-rise commercial use.
In residential areas, 120/240 V single-phase, three-wire service is commonly used for lighting, outlets, and large appliances. Urban areas with high-density loads...
169
Power System Distribution01:25

Power System Distribution

Power system distribution involves delivering electrical energy from power plants to consumers through a network of transmission and distribution systems. The process begins at power plants, where energy from coal, gas, nuclear, water, and wind is converted into electrical energy. These plants use three-phase generators, typically rated between 50 to 1300 MVA, with terminal voltages ranging from a few kV to 20 kV, depending on the size and age of the units.
The transmission system is designed...
351