Reproducibility of FDG PET/CT image-based cancer staging and standardized uptake values with simulated reduction of...

¹⁸F-fluorodeoxyglucose (FDG) PET/CT is widely used for oncologic imaging. This study aimed to evaluate, using data simulation, if reduction of injected FDG dose or PET acquisition time could be technically feasible when utilizing a sensitive commercial PET/CT imaging system, without sacrificing image quality, image-based staging accuracy, or standardized uptake value (SUV) accuracy. De-identified, standard of care oncologic FDG PET/CT datasets from 83 adults with lymphoma, lung carcinoma or breast carcinoma were retrospectively analyzed. All images had been acquired using clinical standard dose and acquisition time on a single PET/CT system. The list mode datasets were retrospectively software reprocessed to achieve undersampling of counts, thus simulating the effect of shorter PET acquisition time or lower injected FDG dose. The simulated reduced-count images were reviewed and compared with full-count images to assess and compare qualitative (subjective image quality, stage stability) and semi-quantitative (image noise, SUVmax stability, signal-to-noise and contrast-to-noise ratios within index lesions driving cancer stage) parameters. While simulated reduced-count images had measurably greater noise, there appeared to be no significant loss of image-based staging accuracy nor SUVmax reproducibility down to simulated FDG dose of 0.05 mCi/kg at continuous bed motion rate of 1.1 mm/sec. This retrospective simulation study suggests that a modest reduction of either injected FDG dose or emission scan time might be feasible in this limited oncologic population scanned on a single PET/CT system. Verification of these results with prospectively acquired images using actual low injected FDG activity and/or short imaging time is recommended.