Resummation of Super-Leading Logarithms

Thomas Becher1, Matthias Neubert2,3, Ding Yu Shao4

  • 1Institut für Theoretische Physik & AEC, Universität Bern, Sidlerstrasse 5, CH-3012 Bern, Switzerland.

Physical Review Letters
|December 3, 2021
PubMed

Related Concept Videos

Inverse z-Transform by Partial Fraction Expansion01:20

Inverse z-Transform by Partial Fraction Expansion

The inverse z-transform is a crucial technique for converting a function from its z-domain representation back to the time domain. One effective method for finding the inverse z-transform is the Partial Fraction Method, which involves decomposing a function into simpler fractions with distinct coefficients. These fractions correspond to known z-transform pairs, facilitating the inverse transformation process.
To begin the process, the poles of the function are identified and the function is...
447
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
48.2K
RL Circuit without Source01:14

RL Circuit without Source

When a DC source is suddenly disconnected from an RL (Resistor-Inductor) circuit, the circuit becomes source-free. Assuming the inductor has an initial current denoted as I0, the initial energy stored in the inductor can be determined.
Applying Kirchhoff's voltage law around the loop of the circuit and substituting the voltages across the inductor and resistor yields a first-order differential equation. A logarithmic equation is obtained by rearranging the terms in this equation,...
1.3K
Superposition Theorem01:18

Superposition Theorem

The superposition principle is a fundamental concept stating that in a linear circuit, the voltage across (or current through) an element can be determined by summing the individual contributions of each independent source acting in isolation. When dealing with linear circuits containing multiple independent sources, this principle serves as a valuable tool for analysis. To apply the superposition principle effectively, one should focus on a single independent source at a time while...
971
Free Energy Changes for Nonstandard States03:25

Free Energy Changes for Nonstandard States

The free energy change for a process taking place with reactants and products present under nonstandard conditions (pressures other than 1 bar; concentrations other than 1 M) is related to the standard free energy change according to this equation:
 
where R is the gas constant (8.314 J/K·mol), T is the absolute temperature in kelvin, and Q is the reaction quotient. This equation may be used to predict the spontaneity of a process under any given set of conditions.
Reaction Quotient...
11.9K
Coulomb's Law and The Principle of Superposition01:15

Coulomb's Law and The Principle of Superposition

Coulomb's Law describes the force experienced by two point charges under each other's presence. But what if there are more than two charges? For example, if there is a third charge, does it experience a force that is a simple combination of the individual forces due to the first two charges? Can it be described mathematically?
The Principle of Superposition answers the question. Yes, Coulomb's Law applies to each pair of charges, and the net force on each charge is the vector sum of...
9.9K