Effect of Different Concentrations of Sodium Hypochlorite on the Compressive Strength of Endodontically Treated Roots

Alexiea Lulue Benjamin Li1, Merete Markvart2, Paul V Abbott3

  • 1University of Copenhagen, Department of Odontology, Section of Clinical Oral Microbiology, Cariology and Endodontics, Copenhagen N, Denmark; UWA Dental School, The University of Western Australia, Crawley, WA, Australia.

Journal of Endodontics
|December 24, 2021
PubMed
Abstract

Related Concept Videos

Ionic Strength: Effects on Chemical Equilibria01:19

Ionic Strength: Effects on Chemical Equilibria

The addition of an inert ionic compound increases the solubility of a sparingly soluble salt. For example, adding potassium nitrate to a saturated solution of calcium sulfate significantly enhances the solubility of calcium sulfate. Le Châtelier's principle cannot predict this shift in the equilibrium. Instead, this could be explained in terms of changes in the effective concentration of the ions in solution in the presence of added inert salt.
In this solution, the primary...
1.9K
Strength of Cement01:20

Strength of Cement

Strength tests for cement are not performed directly on neat cement paste due to difficulty in obtaining consistent, reliable specimens. Instead, cement is typically tested in the form of cement-sand mortar.
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
237
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
207
Ionic Strength: Overview01:12

Ionic Strength: Overview

The ionic strength of a solution is a quantitative way of expressing the total electrolyte concentration of a solution. This concept was first introduced in 1921 by two American physical chemists, Gilbert N. Lewis and Merle Randall, while describing the activity coefficient of strong electrolytes. During the calculation of ionic strength (I or μ), all the cations and anions are considered. However, the concentration (c) of an ion with a greater charge number (z) has a greater contribution...
2.0K
Titration Calculations: Strong Acid - Strong Base02:28

Titration Calculations: Strong Acid - Strong Base

Calculating pH for Titration Solutions: Strong Acid/Strong Base
A titration is carried out for 25.00 mL of 0.100 M HCl (strong acid) with 0.100 M of a strong base NaOH. The pH at different volumes of added base solution can be calculated as follows:
(a) Titrant volume = 0 mL. The solution pH is due to the acid ionization of HCl. Because this is a strong acid, the ionization is complete and the hydronium ion molarity is 0.100 M. The pH of the solution is then:
30.4K