Fatigue resistance of anterior monolithic crowns produced from CAD-CAM materials: An in vitro study

Lithium disilicate and 5 mol% yttria partially stabilized zirconia (5Y-PSZ) are commonly used for anterior restorations. However, studies comparing the durability of 5Y-PSZ and lithium disilicates are sparse.

The purpose of this in vitro study was to investigate the fracture load of anterior monolithic crowns made of 2 lithium disilicates and a 5Y-PSZ under dynamic loading.

Titanium abutments of the maxillary incisors were prepared (N=48, 8 for each group). Monolithic anterior crowns were made from the lithium disilicates (e.max CAD, Rosetta SM) and 5Y-PSZ (Katana UTML). After cementation, the specimens were stored in water for 24 hours and then thermocycled 10 000 times. Dynamic loading (70 N, 200 000 cycles, 1 Hz) was applied to half the specimens. The fracture load was measured by using a universal testing machine. The fracture patterns were analyzed and fractography applied. Two-way ANOVA and the Fisher exact test were used for statistical analysis (α=.05).

The material and dynamic loading affected the fracture load of the anterior monolithic crowns (P<.05). However, there was no interaction between the material and the dynamic loading (P=.079). Both lithium disilicates had higher fracture loads than 5Y-PSZ (P<.05). The fracture load of each specimen was reduced after dynamic loading (P<.05). Lithium disilicate showed marginal and bulk fractures, and 5Y-PSZ presented catastrophic fractures (P<.001).

5Y-PSZ materials with large grains and low flexural strength may be less resistant to fractures under dynamic loading than lithium disilicates.