Related Experiment Video
Updated: Oct 7, 2025

Optimized Fabrication Procedure for High-Quality Graphene-based Moiré Superlattice Devices
Published on: July 11, 2025
Imaging moiré deformation and dynamics in twisted bilayer graphene
Tobias A de Jong1, Tjerk Benschop2, Xingchen Chen2
1Leiden Institute of Physics, Leiden University, P.O. Box 9504, 2300 RA, Leiden, The Netherlands. jongt@physics.leidenuniv.nl.
Abstract:
In 'magic angle' twisted bilayer graphene (TBG) a flat band forms, yielding correlated insulator behavior and superconductivity. In general, the moiré structure in TBG varies spatially, influencing the overall conductance properties of devices. Hence, to understand the wide variety of phase diagrams observed, a detailed understanding of local variations is needed. Here, we study spatial and temporal variations of the moiré pattern in TBG using aberration-corrected Low Energy Electron Microscopy (AC-LEEM). We find a smaller spatial variation than reported previously. Furthermore, we observe thermal fluctuations corresponding to collective atomic displacements over 70 pm on a timescale of seconds. Remarkably, no untwisting is found up to 600 ∘C. We conclude that thermal annealing can be used to decrease local disorder. Finally, we observe edge dislocations in the underlying atomic lattice, the moiré structure acting as a magnifying glass. These topological defects are anticipated to exhibit unique local electronic properties.
Related Concept Videos
Mechanisms of Membrane-bending
Membrane bending can happen due to intrinsic changes in lipid composition or extrinsic association with different proteins. The proteins involved...
Unsymmetric Bending
Mohr's Circle for Plane Strain
Mohr's circle visually represents the strain states under various conditions, which is essential for...
Deformations in a Symmetric Member in Bending
When the member is segmented into tiny cubic elements, it is observed that the primary stress...
Three-Dimensional Analysis of Strain
Transformation of Plane Strain
Under plane strain conditions, typical for members where one dimension significantly exceeds the others, deformations and resultant strains are...

