Related Experiment Video
Updated: Oct 5, 2025

Tilt Testing with Combined Lower Body Negative Pressure: a "Gold Standard" for Measuring Orthostatic Tolerance
Published on: March 21, 2013
Healthcare worker choice and low back force between self-chosen and highest bed height when boosting a patient up in
Robert E Larson1, Sarah T Ridge2, Dustin Bruening2
1Department of Rehabilitation Sciences, Texas Tech University Health Sciences Center, Lubbock, TX, USA.
Abstract:
Healthcare workers have a high rate of low back injury due to patient handling tasks. These workers receive training in patient handling methods such as adjusting bed height, but often ignore them. In this study, 35 healthcare workers completed patient boosts at a self-chosen bed height and again with the bed in a higher standardised position. Motion capture and force data were collected for analysis. Given the choice, less than half of participants adjusted the bed at all and none of them moved the bed to the highest position (99.1 cm). The self-chosen bed position yielded significantly higher low back force than the higher position at L4-L5 and L5-S1 (p = 0.02, p = 0.01 respectively). Low back forces can be reduced by raising the bed prior to engaging in patient handling tasks, which is a simple step that can reduce forces placed on healthcare workers' low backs. Practitioner summary: Healthcare workers experience high rates of low back pain secondary to patient handling tasks. In this cross-sectional crossover study, healthcare workers consistently chose a low bed height when boosting a patient, which resulted in higher low back loads compared to the highest bed height.
More Related Videos
08:40Quantifying Arms and Legs Contributions during Repetitive Electrically-Assisted Sit-To-Stand Exercise in Paraplegics: A Pilot Study
Published on: November 11, 2022
08:24Sit-to-stand-and-walk from 120% Knee Height: A Novel Approach to Assess Dynamic Postural Control Independent of Lead-limb
Published on: August 30, 2016
Related Concept Videos
Special considerations while measuring blood pressure
Monitoring Both Arms:
Monitoring BP in both arms during the initial assessment is advisable, as the systolic value may differ by five to ten mm Hg between arms. For subsequent BP assessments, use the arm with the higher reading.
Pre-Procedural Guidelines for Assessing Blood Pressure
Anatomical Positions
The body is upright, facing forward, and standing erect.
The feet are parallel and flat on the floor.
The arms are hanging by the...