Positional effects of head and/or neck flexion as chin-down posture in normal subjects

Megumi Ozeki1, Hitoshi Kagaya2, Yoko Inamoto1

  • 1Faculty of Rehabilitation, School of Health Sciences, Fujita Health University, Toyoake, Aichi, Japan.

Fujita Medical Journal
|February 3, 2022
PubMed
Abstract

Related Concept Videos

Muscles that Move the Head01:19

Muscles that Move the Head

The muscles that move the head are a dynamic and complex group of structures that work together to facilitate a wide range of head movements, including rotation, flexion, extension, and lateral bending.
The bilateral sternocleidomastoid, or SCM, and the suprahyoid and infrahyoid muscles are significant head flexors. The SCM muscles originate at the sternum and clavicle and attach to the mastoid process of the temporal bone. The SCM contracts bilaterally to bend the head forward, whereas...
3.4K
Anatomical Positions01:11

Anatomical Positions

In anatomy, several standard anatomical positions are used as references for describing the position and orientation of different body parts. These positions help provide a common frame of reference when discussing anatomical structures. The anatomical position is the standard reference point for describing the body's position and orientation. In this position:
The body is upright, facing forward, and standing erect.
The feet are parallel and flat on the floor.
The arms are hanging by the...
16.4K
The Hyoid Bone01:12

The Hyoid Bone

The hyoid bone is a small U-shaped bone located in the upper neck at the level of the inferior mandible, with its tips pointing posteriorly. It does not directly articulate with any other bone in the body. The hyoid acts as the attachment site for the tongue, the larynx, and the pharynx. It is held in position by a series of small muscles attached from above or below. These muscles help to move the hyoid up/down or forward/back in coordination with movements of the tongue, larynx, and pharynx...
3.1K
Unsymmetric Bending - Angle of Neutral Axis01:15

Unsymmetric Bending - Angle of Neutral Axis

Unsymmetrical bending occurs when a structural member is subjected to bending moments in a plane that does not align with the member's principal axes. This scenario typically arises in beams and other structural components when loads are applied at non-ideal angles, introducing complexities in stress analysis.
When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal...
505