Effect of Different Ultrasonic Power on the Properties of RHA Steel Welded Joints

Based on the changes of microhardness, tensile strength, and impact resistance caused by the difference of macroscopic morphology and microstructure of welded joints, this paper studied the effect of different ultrasonic power on the properties of welded joints during the welding of homogeneous armor steel. It is experimentally found that the macroscopic morphology of those joints is very different. Compared with conventional welding, ultrasonic welding can increase the weld depth and the width of the heat-affected zone (HAZ) on either side of the weld. However, only the ultrasonic wave at an appropriate power level can increase the weld width. In addition, appropriate ultrasonic power can significantly improve the grain state of the weld. With the increase of ultrasonic power, the grain size in HAZ will decrease. The microhardness of the weld will first increase and then decrease, while the microhardness of the HAZ will increase. This is basically consistent with the changing trend of impact resistance. An ultrasonic wave can also increase the tensile strength of a welded joint up to 802 MPa, 12.4% higher than that in conventional welding. However, a high-power ultrasonic wave will bring down the tensile strength. This study provides guidance for the selection of ultrasonic-assisted regulation power to achieve the different properties of homogeneous armor steel joints.