Related Experiment Video
Updated: Oct 2, 2025

Experimental Investigation of the Hierarchical Control in DC Microgrids Using a Real-time Simulator
Published on: February 14, 2025
Switching cluster synchronization control of networked harmonic oscillators subject to denial-of-service attacks
1College of Information Science and Technology, Donghua University, Shanghai 201620, China; Engineering Research Center of Digitized Textile and Fashion Technology, Ministry of Education, Donghua University, Shanghai 201620, China.
Abstract:
This paper is concerned with the average cluster synchronization control problem of networked harmonic oscillators under denial-of-service (DoS) attacks. Different from some existing DoS attack models that often necessitate specific statistical characteristics, only the worse-case duration bound of the DoS attacks is required during the control design procedure, which represents the least a priori knowledge of realistic DoS attacks. Then, a novel switching cluster synchronization control scheme, which leverages a position-based feedback control protocol under a non-small delay and a position velocity-based feedback control protocol with a small delay, is developed such that the above two control protocols are selected based on the occurrence of the DoS attacks. Via formulating the resultant synchronization system as a switched time-delay system, a complete-type Lyapunov-Krasovskii functional (LKF) method is further proposed to establish sufficient controller design criteria associated with the duration and frequency of attacks for both synchronous and asynchronous DoS attacks among clusters. Furthermore, an iterative algorithm is designed to calculate the control gain matrices by solving a set of nonlinear matrix inequalities (NLMIs). Finally, a multi-vehicle cooperative control system is presented to demonstrate the validity of the proposed control scheme.
Related Concept Videos
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by:
Damped Oscillations
Although friction and other non-conservative...
Forced Oscillations
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...
Radial System Protection
In a radial system with a fault downstream of the third breaker, ideally, only the third breaker will open, isolating the fault and interrupting the load connected beyond it. The second breaker has a longer delay setting,...
Distributed Loads: Problem Solving

