The effect of target and interferer frequency on across-frequency binaural interference of
Beth Rosen1, Matthew J Goupell1
1Department of Hearing and Speech Sciences, University of Maryland, College Park, Maryland 20742, USA.
Abstract:
Across-frequency binaural interference occurs when the sensitivity to changes in interaural differences in a target sound is decreased by a spectrally remote diotic interfering sound. For interaural time differences (ITDs), low-frequency (e.g., 0.5 kHz) interferers cause more interference on high-frequency (e.g., 4 kHz) targets than vice versa. For interaural level differences (ILDs), however, it is unclear if a frequency dependence exists. Therefore, ILD discrimination thresholds and across-frequency binaural interference were measured for target and interferer frequencies between 0.5 and 8 kHz (for tones) or 12 kHz (for narrowband noises). For tones, 8-kHz targets experienced the least interference and 8-kHz interferers produced the most interference, suggesting that higher-frequency ILDs are a more heavily weighted localization cue than lower-frequency ILDs. For narrowband noises, the frequency-dependent interference patterns increased in complexity in comparison to tones. Low-frequency ITD dominance (from randomly varying onset ITDs) and grouping cues (e.g., envelope modulations) might explain some of the complexity in the interference patterns for the noises. These data contribute to a better understanding of across-frequency ILD processing, which remains poorly understood.
Related Concept Videos
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
Sound Waves: Interference
Echo
Imagine the sound is reflected back to the ears. Assuming that the source is very close to the human, the difference between hearing the two sounds—the emitted sound and the reflected sound—may be more than the minimum time for perceiving distinct sounds. If this is the case,...
Perceiving Loudness, Pitch, and Location
Place theory, or place coding, suggests that different pitches are heard because various sound waves activate specific locations along the cochlea's basilar membrane. The brain determines the pitch of a sound by...
Frequency Response of BJT
Low-Frequency Response: At low frequencies, the behavior of the BJT is determined by its DC bias point, which is set by the...
Doppler Effect - II


