Related Experiment Video
Updated: Oct 1, 2025

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
Swelling Characteristics and Interaction Mechanism of High-Rank Coal during CO2 Injection: A Molecular Simulation
Kui Dong1, Zhiwei Zhai2, Bingyi Jia3
1Department of Geoscience and Engineering, Key Laboratory of Coal and Coal-measure Gas Geology in Shanxi Province, Taiyuan University of Technology, Taiyuan 030024, China.
Abstract:
In CO2-enhanced coalbed methane (CO2-ECBM) engineering, accurate knowledge of the interaction mechanism of CO2 and coal matrix is crucial for improving the recovery of CH4 and contributing to the geological sequestration of CO2. This study is performed to prove the accuracy of molecular simulation and calculate the variation characteristics of pore structure, volumetric strain, mechanical properties, Fourier transform infrared (FT-IR) spectra, and the system free energy by molecular dynamics (MD) and grand canonical Monte Carlo (GCMC) methods. According to the obtained results, a relationship between pore structure, swelling strain, mechanical properties, chemical structure, and surface free energy was established. Then, the correlation of various coal change characteristics was analyzed to elucidate the interaction mechanism between CO2 and coal. The results showed that (1) the molecular simulation method was able to estimate the swelling mechanism of CO2 and coal. However, because the adsorption capacity of the molecular simulate is greater than that of the experiment and the raw coal is softer than the macromolecular structure, the molecular results are slightly better than the experimental results. (2) As pressure increased from 0 to 4 MPa, the intramolecular pores and sorption-induced strain changed significantly, whereas when the pressure increased from 4 to 8 MPa (especially at 6-8 Mpa), there was an increase of the intermolecular pores and mechanical properties and transition from elastic to plastic. In addition, when the pressure was >8 MPa, the coal matrix changed slightly. ScCO2 with a higher adsorption capacity results in greater damage and causes larger alterations of coal mechanical properties. (3) The change of the coal matrix is essentially controlled by the surface free energy of the molecular system. E valence affects the aromatic structure and changes the volume of the intramolecular pores, thus affecting the sorption-induced strain change rate. E non affects the length of side chains and the disorder degree of coal molecules and changes the volume of the intramolecular pores, thus affecting the mechanical property change rate. Our findings shed light on the dynamic process of coal swelling and provide a theoretical basis for CO2 enhancing the recovery of CH4 gas in coal.
More Related Videos
08:02Reservoir Condition Pore-scale Imaging of Multiple Fluid Phases Using X-ray Microtomography
Published on: February 25, 2015
11:38In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO2 Adsorption in UiO-66 Metal-Organic Framework
Published on: February 1, 2020
Related Concept Videos
Phase Diagrams
Real Gases: Effects of Intermolecular Forces and Molecular Volume Deriving Van der Waals Equation
Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
Entropy and Solvation