[The Safety of Bladder Irrigation with Solution G Prepared with Tap Water]

Koji Koizumi1, Mamiko Yazawa2, Michiyo Baba2

  • 1The Department of Urology, Showa Inan General Hospital.

Related Concept Videos

Urinary Tract Infection IV: Nursing Management01:17

Urinary Tract Infection IV: Nursing Management

In managing urinary tract infections (UTIs) in nursing, a comprehensive assessment is essential. Begin by gathering subjective data, such as the patient’s complaints of dysuria (painful urination), urinary frequency, urgency, suprapubic pain, and any lower abdominal discomfort. This information can be complemented by questions regarding previous UTIs, sexual activity, and personal hygiene practices, which can provide insight into risk factors. Objective assessment should focus on signs...
111
Urinary Tract Infection III: Diagnostic Studies and Interprofessional Care01:30

Urinary Tract Infection III: Diagnostic Studies and Interprofessional Care

A healthcare provider can diagnose a urinary tract infection (UTI) through several methods:Medical History and Symptoms: The provider will take a detailed medical history and ask about symptoms such as frequent urination, burning sensation during urination, and lower abdominal pain.Urinalysis: A clean-catch urine sample is collected in a sterile container and tested for the presence of bacteria, white blood cells (leukocytes), nitrites, blood, and protein. The presence of leukocytes and...
59
Handwashing I: Introduction and Types of Equipment01:18

Handwashing I: Introduction and Types of Equipment

Handwashing is hand hygiene with plain or antimicrobial soap and water to physically remove dirt, organic material, and microorganisms. However, it may not kill all microorganisms. The handwashing procedure requires a hand wash basin, liquid soap, paper towels, a domestic waste bin, and disposable nail cleaner as optional equipment.
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated....
4.5K
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
198
Urine Studies II: Urine Culture and Sensitivity Test01:26

Urine Studies II: Urine Culture and Sensitivity Test

A urine culture and sensitivity test is a diagnostic procedure used to identify urinary tract bacterial infections and determine the most effective antibiotics for treatment. This test is generally preferred when a patient shows manifestations of a urinary tract infection, such as frequent or painful urination, cloudy or foul-smelling urine, or lower abdominal pain.Purpose of the TestThe primary goals of a urine culture and sensitivity test are to:Determine the specific bacteria causing the...
173
Handwashing II: Pre-procedure and Initial Procedure Steps01:19

Handwashing II: Pre-procedure and Initial Procedure Steps

The pre-procedure steps of handwashing include removing jewelry and rolling up sleeves. However, many organizations allow staff to wear wedding rings.
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury.  The nails must be short and clean, without nail...
1.2K