Related Experiment Video
Updated: Sep 30, 2025

Detecting the Water-soluble Chloride Distribution of Cement Paste in a High-precision Way
Published on: November 21, 2017
Studies on Cement Pastes Exposed to Water and Solutions of Biological Waste
Agnieszka Sujak1, Michał Pyzalski2, Karol Durczak1
1Department of Biosystems Engineering, Faculty of Environmental and Mechanical Engineering, Poznań University of Life Sciences, Wojska Polskiego 50 Street, 60-627 Poznań, Poland.
Abstract:
The paper presents studies on the early stages of biological corrosion of ordinary Portland cements (OPC) subjected to the reactive media from the agricultural industry. For ten months, cement pastes of CEM I type with various chemical compositions were exposed to pig slurry, and water was used as a reference. The phase composition and structure of hydrating cement pastes were characterized by X-ray diffraction (XRD), thermal analysis (DTA/TG/DTG/EGA), and infrared spectroscopy (FT-IR). The mechanical strength of the cement pastes was examined. A 10 to 16% decrease in the mechanical strength of the samples subjected to pig slurry was observed. The results indicated the presence of thaumasite (C3S·CO2·SO3·15H2O) as a biological corrosion product, likely formed by the reaction of cement components with living matter resulting from the presence of bacteria in pig slurry. Apart from thaumasite, portlandite (Ca(OH)2)-the product of hydration-as well as ettringite (C3A·3CaSO4·32H2O) were also observed. The study showed the increase in the calcium carbonate (CaCO3) phase. The occurrence of unreacted phases of cement clinker, i.e., dicalcium silicate (C2S) and tricalcium aluminate (C3A), in the samples was confirmed. The presence of thaumasite phase and the exposure condition-dependent disappearance of CSH phase (calcium silicate hydrate), resulting from the hydration of the cements, were demonstrated.
More Related Videos
06:27Expression of Cementitious Pore Solution and the Analysis of Its Chemical Composition and Resistivity Using X-ray Fluorescence
Published on: September 23, 2018
05:38Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Related Concept Videos
Porosity in Cement Paste
The balance of water to cement in the mix is...
Soundness of Cement
Testing Water Quality
Hydration of Cement
Types of Cement II
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...