Force-Generation by the Trans-Envelope Tol-Pal System

Melissa N Webby1, Daniel P Williams-Jones1, Cara Press1

  • 1Department of Biochemistry, University of Oxford, Oxford, United Kingdom.

Related Concept Videos

Net Torque Calculations01:19

Net Torque Calculations

When a mechanic tries to remove a hex nut with a wrench, it is easier if the force is applied at the farthest end of the wrench handle. The lever arm is the distance from the pivot point (the hex nut in this case) to the person’s hand. If this distance is large, the torque is higher. Only the component of the force perpendicular to the lever arm contributes to the torque. Therefore, pushing the wrench perpendicular to the lever arm is more advantageous. If multiple people apply force to...
9.7K
Power Expended by a Constant Force00:57

Power Expended by a Constant Force

The relationship between work done and the time taken to do it can be explained using the concept of power. For example, several sprinters in a race may have the same velocity when they reach the finish line, therefore doing the same amount of work, but the winner does it in the least amount of time. Thus, power is defined as the rate of doing work. Since work can vary as a function of time, the average power is defined as the work done during a time interval, divided by the time interval.
7.7K
Frictional Forces on Flat Belts01:28

Frictional Forces on Flat Belts

Flat belts are commonly used in various industrial applications for transmitting power from one pulley to another. When a flat belt is wrapped around a set of pulleys, it experiences different tensions at the driving pulley ends due to the friction between the belt and pulley surface. When the pulley moves in a counterclockwise direction, the tension T2 on the opposite side of the pulley where the belt is moving away from is higher than the tension T1 on the side where the belt is moving...
1.1K
Work Done on a System by External Force01:11

Work Done on a System by External Force

The work done by an external force on a particle changes its kinetic energy. However, internal forces must also be considered for a system of interacting particles. The potential energy formulation helps formulate the effect of internal forces. The net work done by an external force can be written in terms of the total change of mechanical energy, which includes both kinetic and potential energies.
In the presence of a non-conservative opposing force, like friction, some part of the work done...
2.3K
Two-Dimensional Force System01:20

Two-Dimensional Force System

A two-dimensional system in mechanical engineering involves the analysis of motion and forces in a plane. A two-dimensional force vector can be resolved into its components as:
1.1K
Forced Oscillations01:06

Forced Oscillations

When an oscillator is forced with a periodic driving force, the motion may seem chaotic. The motions of such oscillators are known as transients. After the transients die out, the oscillator reaches a steady state, where the motion is periodic, and the displacement is determined.
6.9K