Related Experiment Video
Updated: Sep 29, 2025

Preparation of Aligned Steel Fiber Reinforced Cementitious Composite and Its Flexural Behavior
Published on: June 27, 2018
An Improved Composition of CoFeSiB Alloy for Orthogonal Fluxgates
Mattia Butta1, Michal Janošek1, Jakub Pařez1
1Faculty of Electrical Engineering, Czech Technical University in Prague, 166 27 Prague, Czech Republic.
Abstract:
Orthogonal fluxgates in fundamental mode based on (Co0.94Fe0.06)72.5Si12.5B15 cores have recorded very low noise in literature, especially if Joule annealing is performed on the core for a short period of time. However, for annealing time longer than 20-30 min, the noise of the sensor has a tendency to increase. In this work, we investigated this phenomenon, and we have found its origin in a monotonic increase of magnetostriction during the annealing process. We show that the wires with vanishing magnetostriction in their as-cast form exhibit positive magnetostriction after long-time annealing (more than 30 min), which increases the noise of the sensor. After researching the effect of the magnetostriction after annealing on the noise, we propose an alloy with a reduced amount of iron. Less iron leads to a larger as-cast negative magnetostriction, which becomes almost zero after long-time annealing (60 min), bringing further reduction of noise. We prove this effect on two wires from two different manufacturers, although with the same composition. The noise decrease with prolonged annealing is mainly observable in the low-frequency region: at 100 mHz, the noise of a single-wire sensor decreased from 20pT/Hz to 6pT/Hz when the annealing time was prolonged from 10 to 60 min.
More Related Videos
08:55Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses
Published on: June 7, 2018
14:51An Available Technique for Preparation of New Cast MnCuNiFeZnAl Alloy with Superior Damping Capacity and High Service Temperature
Published on: September 23, 2018
Related Concept Videos
Biasing of FET
In an N-channel JFET, the structure consists of N-type material forming the channel on a P-type substrate, with the...
Ferromagnetism
Biasing of Metal-Semiconductor Junctions
In Schottky junctions, where the semiconductor is n-type, applying a positive voltage to the metal relative to the semiconductor reduces its Fermi...
Colors and Magnetism
When atoms or molecules absorb light at the proper frequency, their electrons are excited to higher-energy orbitals. For many main group atoms and molecules, the absorbed photons are in the ultraviolet range of the electromagnetic spectrum, which cannot be detected by the human eye. For coordination compounds, the energy difference between the d orbitals often allows photons in the visible range to be absorbed and emitted, which is seen as colors by the human...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
Ferrocement