Effects of heating rate on thermal degradation behavior and kinetics of representative thermoplastic wastes

Waste thermoplastics are the most common solid wastes, and thermal degradation has excellent advantages in the disposal of these wastes and obtaining valuable hydrocarbon fuels. As a significant factor, the heating rate is crucial to the thermal degradation process. Consequently, thermal degradation behavior and kinetics of representative thermoplastics under different heating rates were investigated by using thermogravimetric analysis and differential scanning calorimetry in the air. Kinetic parameters were estimated by using the Coats-Redfern method. Subsequently, the Shuffled Complex Evolution (SCE) method was used to optimize kinetic parameters, and the optimized results were compared with the calculated kinetics of distributed activation energy model (DAEM) method to find the effects of heating rate on kinetic parameters. The results showed that with the increase of heating rate, thermogravimetric curves moved to the right, which corresponded to a higher temperature range. The number of mass loss rate peaks and exothermic peaks decreased. Additionally, activation energy was the same at the determined minimum and maximum heating rates, and other heating rates had little effect on kinetic parameters. Moreover, the calculated activation energy of the DAEM method at the minimum heating rate of 5 K/min was closest to the optimized values of the SCE method, indicating that the lower the minimum heating rate was, the more accurate the activation energy was.