Quasi-isentropic compression of LiH above 400 GPa using magnetocumulative generator

The knowledge of high-pressure behavior of LiH is significant for the validation of fundamental theoretical models and applications in thermonuclear materials and potential energy supplies. The compressibility of ⁷LiH under isentropic compression at high pressure was investigated experimentally and theoretically. The experimental technique for quasi-isentropic compression with low-density materials was developed using the magnetocumulative generator CJ-100 and x-ray flash radiography. The x-ray images and extracted interface of the sample target in dynamic flash radiography experiments were obtained. According to each interface size of the target both before and after compression, the compression ratio of ⁷LiH and reference material aluminum was obtained. The density of the reference and using its known isentropic curve provide the pressure in the reference. The pressure in ⁷LiH was deduced from the pressure in the reference and using the calculated gradient correction factor. The quasi-isentropic data point at 438 GPa was obtained experimentally. A semiempirical three-term complete equation of state was constructed and validated for ⁷LiH using the theory of Mie-Grüneisen-Debye with experimental data from the literature. The quasi-isentrope data point is reasonably consistent with the theoretical results. The quasi-isentropic experimental techniques and results broaden the existing research scope and are practical and helpful to further validate theoretical models in the future.