Related Experiment Video
Updated: Sep 24, 2025

Safety Precautions and Operating Procedures in an ABSL-4 Laboratory: 3. Aerobiology
Published on: October 3, 2016
Airborne contamination of the dental operatory during activities performed with open or closed windows
James R Collins1, Vanessa Warden2, Ana Vargas2
1Department of Periodontology, Pontificia Universidad Católica Madre y Maestra, Santo Domingo, Dominican Republic, jamescollins@pucmm.edu.do.
Purpose:
To quantify the biological contamination of a dental operatory environment using a biological tracer.
Methods:
A Streptococcus mutans suspension was infused into the mouth of a phantom, and an operator performed standardized dental procedures using an air turbine, a contra-angle handpiece, or an ultrasonic scaler either with windows open or closed. The presence of the tracer was measured by placing Petri dishes with a selective medium at 18 sites on the dental unit and 38 sites in the surrounding operatory environment.
Results:
The contamination was drastically reduced when windows were opened, no matter which handpiece was used. Air turbine spread significantly higher contamination compared to contra-angle and scaler. All tested instruments spread the tracer over the entire dental unit and the surrounding environment, including the walls and ceiling; however, higher contamination levels were detected on the dental unit compared to the operatory surfaces. Opening windows during dental operative procedures greatly reduced contamination levels for all handpieces and can be recommended for reducing airborne contamination levels.
Clinical Significance:
The significant levels of airborne contamination produced when operating dental handpieces can be significantly reduced by natural ventilation, i.e., simply opening the windows.
Related Concept Videos
Transmission-based Precautions II: Airborne and Protective Environment
Airborne precautions:
Use airborne precautions when treating patients known or suspected to have diseases that spread through the air—for example, tuberculosis or measles. These organisms are present in smaller droplets expelled by an infected person and...
Transmission-based Precautions I: Contact, Enteric, and Droplets
Contact Precautions:
Contact precautions are the measures taken to prevent the transmission of infectious agents, especially epidemiologically important microorganisms such as MRSA or influenza, primarily transmitted through direct or indirect contact with an...
Suctioning the Oropharyngeal Airway
After assembling the equipment, the nurse should practice hand hygiene and don appropriate PPE according to infection control guidelines to avoid the...
Factors Affecting Pulmonary Ventilation
Alveolar Surface Tension
The alveolar fluid lines the luminal surface of the alveoli and exerts a force called surface tension. This force is caused by the polar water molecules in the liquid being more strongly attracted to each...
Oxygen Delivering System II: Venturi Mask and Transtracheal Oxygen
Venturi Mask
The Venturi mask, named after the Venturi effect, is designed to deliver precise oxygen concentrations. It consists of a large tube with an oxygen inlet that narrows down, causing a pressure drop that pulls air in through adjustable side ports. The mask is a lightweight,...
Pulmonary Tuberculosis I
Causative Organism
The primary infectious agent causing tuberculosis is Mycobacterium tuberculosis, a slow-growing, acid-fast, aerobic rod that exhibits sensitivity to heat and ultraviolet light. Instances of Mycobacterium bovis and Mycobacterium avium contributing to the development of TB infection are rare.
Mode of...

