The effects of amalgam contamination and different surface modifications on microleakage of dentin bonded to bulk...

To evaluate the effect of amalgam contamination, different surface treatments, and adhesive protocols on dentin microleakage to bulk-fill composite resin material.

Forty teeth were fixed in (polyvinyl siloxane) PVS molds, and the Class II cavities were placed on mesial and distal aspects. Thirty teeth were restored by amalgam and thermocycled to 10,000 cycles (5 and 55 °C, 30-s dwell time). The rest were restored with Filtek one Bulk Fill composite without amalgam predecessor. Samples were divided into: G1 (dentin pretreated with 2% chlorhexidine gluconate), G2 (0.5 mm of dentin was removed), G3 (no surface modification), and G4 (control, where composite was bonded to sound dentin without amalgam predecessor.). Single Bond Universal Adhesive system was used to bond the composite material, by using the etch-and-rinse protocol in the mesial cavity preparation and self-etch protocol in the distal. Specimens underwent thermocycling for 5000 cycles, then embedded in silver nitrate and sectioned for stereomicroscope examination. Descriptive statistics, Mann-Whitney U test, and Kruskal-Wallis test were used to analyze the results at p < 0.05.

The highest microleakage score values (4.00) were found in the G2, and G4 in etch-and-rinse protocol. While the lowest scores were found in G2 when using self-etching protocol (1.5). Lower microleakage values were associated with the chlorhexidine treatment group for both adhesive protocols. No significant differences were found between amalgam contaminated and non-contaminated groups.

Amalgam contamination did not affect microleakage. Self-etching adhesive protocol significantly reduced microleakage for all groups irrespective of the surface treatment. Chlorhexidine pretreatment improved microleakage for both adhesive protocols but had no significant effect.