Related Experiment Video
Updated: Sep 22, 2025

Biomechanical Analysis Methods to Assess Professional Badminton Players' Lunge Performance
Published on: June 11, 2019
Assessment of the steady glide phase in ski jumping
Ola Elfmark1, Gertjan Ettema2, Matthias Gilgien3
1Department of Civil and Environmental Engineering, Centre for Sport Facilities and Technology, Norwegian University of Science and Technology, N-7491 Trondheim, Norway.
Abstract:
The purpose of this investigation was to compare how key variables of the steady glide phase relate to performance in the two hill sizes used in World Cup and Olympic competitions, i.e, normal and large hills. In this study, 38 and 33 jumps of elite ski jumpers were measured with a differential global navigation satellite system (dGNSS) on a normal (HS106) and large hill (HS140), respectively. For the steady glide phase, the average aerodynamic forces, lift-to-drag-ratio (LD-ratio), vertical and horizontal acceleration and velocity were measured and related to the jump distance as a performance outcome. The aerial time difference between the two hill sizes was 1.1s, explained by the time spent in the steady glide phase. The results for HS106 were in line with the assumptions in recent literature, which propose that the performance is largely determined by the take-off and glide preparation. Hence for normal hills, skiers should aim to reduce vertical acceleration through high aerodynamic forces during the glide phase. Also, no correlation was observed between the LD-ratio and jump length. The data from the large hill indicate that the performance during the steady glide is very important for performance; hence clear differences were found compared to the normal hill. On a large hill, the aim should be to minimize the horizontal deceleration by reducing the aerodynamic drag. A high LD-ratio was correlated to jump length for HS140 and seen to be one of the most important performance factors.
Related Concept Videos
Energy Diagrams - II
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...
Work Done Over an Inclined Plane
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...
Elevation of Intermediate Points on Vertical Curves
Energy Diagrams - I
Take the example of a skater on a parabolic ramp. The potential energy at different points along the ramp will be proportional to the height of the ramp, which varies quadratically with the horizontal position on the ramp. As the skater moves down the ramp from the highest position,...
Absolute Motion Analysis- General Plane Motion
As the drone's propellers rotate, an upward force is generated that counteracts the force of gravity, enabling the drone to lift off from the ground. This initial movement of the drone is along a straight path, representing a form of translational motion. In this phase, every point on the...
Projectile Motion
When an object falls under gravity and has no...

