Resistive electrode array (REA) for radiotherapy beam monitoring and quality assurance

We have developed a new type of detector array for monitoring of radiation beams in radiotherapy. The detector has parallel-plane architecture with multiple large-area uniform thin-film electrodes. At least one of the electrodes is resistive and has multiple signal readouts spread out along its perimeter. The integral dose deposited in the detector gives rise to multiple signals that depend on the distribution of radiation with respect to resistive electrode array (REA) geometry. The purpose of the present study was to experimentally determine basic detector response to MLC collimated x-ray fields. Two detector arrays have been characterized: circular and rectangular. The current and electrostatic potential distribution within the resistive electrode are governed by the Laplace and continuity equations with boundary conditions at the border with the readouts. Measurements for pencil beams showed that signal strength depends primarily on the distances between the location of the pencil beam and the readouts. Measurements for larger irregular MLC showed that signals as a function of time are quasi-linear with respect to MLC position and are proportional to the MLC area. Derivation of clinically relevant radiation beam parameters from REA signals, such as MLC position, MLC gap size and monitor unit per MLC segment relies on the detector response model with empirical model parameters. An approximate analytical detector response model was proposed and used to fit experiment data.