Nonlinear Temperature-Dependent Phonon Decay in Heavily Doped Silicon: Predominant Interferon-Mediated Cold Phonon

Chanchal Rani1, Manushree Tanwar1, Suchita Kandpal1

  • 1Materials and Device Laboratory, Department of Physics, Indian Institute of Technology Indore, Simrol 453552, India.

Related Concept Videos

Types of Semiconductors01:20

Types of Semiconductors

Intrinsic semiconductors are highly pure materials with no impurities. At absolute zero, these semiconductors behave as perfect insulators because all the valence electrons are bound, and the conduction band is empty, disallowing electrical conduction. The Fermi level is a concept used to describe the probability of occupancy of energy levels by electrons at thermal equilibrium. In intrinsic semiconductors, the Fermi level is positioned at the midpoint of the energy gap at absolute zero. When...
949
Atomic Spectroscopy: Effects of Temperature01:27

Atomic Spectroscopy: Effects of Temperature

Atomization, converting samples into gas-phase atoms and ions, is essential for atomic spectroscopy. The flame temperature required for atomization affects the efficiency of the atomic spectroscopic methods by increasing the atomization efficiency and the relative population of the excited and ground states.
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
484
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
201
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
13.3K
Fermi Level01:18

Fermi Level

The Fermi-Dirac function is represented by an S-shaped curve indicating the probability of an energy state being occupied by an electron at a given temperature. The Fermi level is the energy level at which there is a fifty percent chance of finding an electron, and it is positioned between the lower-energy valence band and the higher-energy conduction band.
At absolute zero temperature, electrons fill all energy states up to the Fermi level, leaving upper states empty. As the temperature rises,...
851
Thermal Strain01:19

Thermal Strain

Thermal strain is a concept that arises when we consider how temperature changes affect structures. Unlike the conventional assumption that structures remain constant under load, real-world scenarios often involve temperature fluctuations that can significantly impact these structures. Consider a homogeneous rod with a uniform cross-section resting freely on a flat horizontal surface. If the rod's temperature increases, the rod elongates. This elongation is proportional to the temperature...
2.5K