Related Experiment Video
Updated: Sep 20, 2025

A Freeze-Thawing Method to Prepare Chitosan-Polyvinyl alcohol Hydrogels Without Crosslinking Agents and Diflunisal Release Studies
Published on: January 14, 2020
Freeze-thaw alternations accelerate plasticizers release and pose a risk for exposed organisms
Siqi Wu1, Zhongli Chen1, Min Zhou1
1Key Laboratory of the Ministry of Education for the Ecological Environment of the Three Gorges Reservoir Area, Chongqing University, Chongqing 400030, China.
Abstract:
The application of plastic mulch films brings convenience to agricultural production, but also causes plastic waste that can be degraded into microplastics (MPs). However, little is known about the fate of plastic waste in agricultural ecosystem under freeze-thaw alternation in middle and high latitudes, as well as in highlands around the world. Whether the release of plasticizers, i.e. phthalate esters (PAEs), under such conditions would pose a potential risk to exposed organisms due to bioaccumulation is also unknown. To fill these data gaps, the agricultural fields in Liaoning of China with typical freeze-thaw alternation was selected as the study area. The transformation of plastic film was demonstrated by simulation freeze-thaw alternating from -30 to 20 ℃. Soil samples were collected to investigate the patterns of MP composition, abundance, and distribution. Concurrently, the concentrations of two PAEs including bis(2-ethylhexyl) phthalate (DEHP) and diethyl phthalate (DEP) in soils were analyzed to provide information on the correlation between MPs abundance and PAEs concentrations as well as potential risks. The results showed that freeze-thaw alternating can accelerate the formation of MPs and release of PAEs from plastic waste. The abundance of MPs was positively correlated with the concentration of PAEs. Soil PAEs ranged from 3268 ± 213-6351 ± 110 μg/kg, indicating that over 40 % of the PAEs were transferred from plastic films to soils. Such residual amounts could pose risk for exposed organisms. Hence, the current study suggested that special concerns should be given to the release plasticizers in plastic waste of agricultural soils.
Related Concept Videos
Frost Action on Concrete
This freeze-thaw cycle primarily causes surface scaling, where...
Plasticizers
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
Responses to Heat and Cold Stress
Frost Resistant Concrete
Introducing microscopic air bubbles into the concrete mix through air entrainment creates small voids that accommodate ice expansion, thereby reducing internal pressures and preventing cracking. The optimal amount of...
Cold Weather Concreting
To counteract the negative impacts of cold weather, ensuring...
Factors Influencing Microbial Growth: Temperature

