Experimental Investigation on Seepage Characteristics of Clay-Structure Interface after Shear Deformation

There exist shear and seepage behaviors on the interface between clay core and concrete slab in clay core dams. In order to investigate the seepage characteristics of the clay-structure interface after shear deformation, a shear-seepage test system is proposed, in which the seepage direction is perpendicular to the shear direction. The shear test and shear-seepage test are performed on clay-metal and clay-mortar interfaces under different normal stresses (100, 200, 400, 800, and 1600 kPa). The shear stress-deformation curves of two clay-structure interfaces exhibit softening behavior and residual friction behavior. The interface roughness can enhance peak and residual shear strength and increase peak displacement. The shear-seepage test results show that specimen permeability decreases first and then increases to a stable value as shear deformation increases under low normal stress, while it decreases continuously and then retains stability under high normal stress. The interface roughness enhances specimen permeability under low normal stress, whereas it has a weak effect on specimen permeability under high normal stress. Compared with initial permeability, shear deformation reduces specimen permeability rather than raise it. The ratio of stabilized permeability coefficient to initial value ranges from 0.6 to 0.8. The clay-structure interface still has a good resistance to seepage failure after shear deformation. The shear dilation features and interface pore decrease caused by shear behavior are the internal attributions of clay-structure specimen permeability evolution.