Crack-Resistant Amino Resin Flame-Retardant Coatings Using Waterborne Polyurethane as a Co-Binder Resin

Surface cracking is a major issue in amino resin-based flame-retardant coatings, which can be reduced by mixing flexible resins into the coatings. In this study, flexible waterborne polyurethane (WPU) was added into a melamine-modified, urea-formaldehyde, resin-based intumescent flame retardant (MUF-IFR) coating. A molecular chain of WPU was inserted into the MUF network and formed a WPU/MUF-semi-IPN structure. The cracking resistance of the coating was gradually enhanced with the increase in WPU content. When the WPU content exceeded 25% of the total resin, there were no cracks in the coatings after crack-resistance tests. The coatings before and after toughening showed good transparency on wood surfaces. The influence of WPU on char formation and flame retardant properties were explored by TGA, SEM, and cone calorimetry. The results showed that the decomposition of WPU occurred before char formation, which decreased the integrity of the coating and damaged the compactness of the char. Therefore, the addition of WPU reduced the expansion height and the barrier capacity of the char as well as the flame retardant properties of the coating. When the amount of WPU was 25% of the total resin, compared to the non-WPU coating, the average heat release rate in 300 s (AveHRR_300s) and the total heat release at 300 s (THR_300s) of the samples were increased by 45.8% and 35.7%, respectively. However, compared to the naked wood, the peak heat release rate (pHRR₁), AveHRR_300s, and THR_300s of the samples with the coating containing 25% WPU were decreased by 64.2%, 39.0%, and 39.7%, respectively. Therefore, the thermal stability of WPU affected char formation. The amount of WPU added should be chosen to be the amount that was added just before the coating cracked.