Many receptor binding ligands are hydrophilic; they do not cross the cell membrane but bind to cell-surface receptors. Thus, their message must be relayed by second messengers present in the cell cytoplasm. There are several second messenger pathways, each with its own way of relaying information. For example, the G protein-coupled receptors can activate both phosphoinositol and cyclic AMP (cAMP) second messenger pathways. The phosphoinositol pathway is active when the receptor induces...

When a ligand binds to a cell-surface receptor, the receptor's intracellular domain changes shape, which may either activate its enzyme function or allow its binding to other molecules. The initial signal is amplified by most signal transduction pathways. This means that a single ligand molecule can activate multiple molecules of a downstream target. Proteins that relay a signal are most commonly phosphorylated at one or more sites, activating or inactivating the protein. Kinases catalyze...

Group polarization is the strengthening of an original group attitude following the discussion of views within a group (Teger & Pruitt, 1967). That is, if a group initially favors a viewpoint, after discussion the group consensus is likely a stronger endorsement of the viewpoint. Conversely, if the group was initially opposed to a viewpoint, group discussion would likely lead to stronger opposition.

A sound engineer at a music company recently encountered a problem. The output from their newly acquired studio's vintage mixing console was too low for the requirements of modern recording equipment. To rectify this situation, the engineer decided to design an audio pre-amplifier using an operational amplifier (op-amp) to boost the signal level.
The specifications for the pre-amplifier were clear. It needed to amplify the audio signal by a factor of 10, have an input impedance above 10...

When we hear a sound, our nervous system is detecting sound waves—pressure waves of mechanical energy traveling through a medium. The frequency of the wave is perceived as pitch, while the amplitude is perceived as loudness.

In designing and analyzing filters, resonant circuits, or circuit analysis at large, working with standard element values like 1 ohm, 1 henry, or 1 farad can be convenient before scaling these values to more realistic figures. This approach is widely utilized by not employing realistic element values in numerous examples and problems; it simplifies mastering circuit analysis through convenient component values. The complexity of calculations is thereby reduced, with the understanding that...