Two-Step Glass Molding Process for Forming Glass Edges with Obtuse Angles for Mobile Displays

The domain of edge displays with 2.5D or 3D curved designs has been expanded to improve user convenience. The currently available 3D cover glass offers a limited curvature radius of at least 5 mm and a curvature less than 88°, due to limitations in the undercuts and formability of parts. The development of a full 3D cover, applicable to next-generation displays, requires cover glass molding technology with a curvature exceeding 90°. Here, a mold design and molding process, which addresses the current limitations by dividing the existing glass molding press (GMP) process into two stages, is proposed. The bending geometry of the glass prepared on the basis of the proposed mold design plan during single-step compression forming and two-step compression forming was predicted using commercial analysis software. A molding product with a curvature radius of 2.5 mm and an angle of curvature of 138.9° was produced when process conditions with bending by up to 180° with no damage were applied during actual forming experiments. Further research on annealing and cooling processes of GMP is expected to enable the design and process implementation to manufacture curved glass with a single curvature of at least 90° and multiple curvatures.