Recycled HDPE/Natural Fiber Composites Modified with Waste Tire Rubber: A Comparison between Injection and...

With the objective of turning wastes into added-value materials, sustainable and fully recycled wood-plastic composites were reinforced by waste tire rubber particles to show balanced properties and potentially low-cost materials. Recycled high density polyethylene (rHDPE) was compounded (melt extrusion) with flax fiber (FF) and waste regenerated tire rubber (RR) to investigate the effect of mixing ratio, coupling agent (maleated polyethylene, MAPE) and molding process (injection and compression molding) on the properties of hybrid composites. In particular, a complete set of characterization was performed including thermal stability, phase morphology and mechanical properties in terms of tension, flexion and impact, as well as hardness and density. Adding 40 wt.% of flax fibers (FF) increased the tensile (17%) and flexural (15%) modulus of rHDPE, while the impact strength decreased by 58%. Substitution of FF by waste rubber particles improved by 75% the impact strength due to the elasticity and energy absorption of the rubber phase. The effects of impact modification were more pronounced for rHDPE/(FF/RR) compatibilized with MAPE (10 wt.%) due to highly improved interfacial adhesion and compatibility. The results also suggest that, for a fixed hybrid composition (FF/RR, 25/55 wt.%), the injection molded composites have a more homogenous morphology with a uniform distribution of well embedded reinforcements in the matrix. This better morphology produced higher tensile strain at break (12%) and impact strength (9%) compared to compression molded samples.