Investigation of Mechanical and Tribological Behaviors of Aluminum Based Hybrid Metal Matrix Composite and...

Aluminum metal matrix composites are potential materials for aerospace and automobile industrial applications due to their enhanced mechanical and tribological properties. Aluminum reinforced with silicon carbide particles has been developed with enhanced mechanical and tribological behavior, but it lacks wettability between matrix and reinforcement causing weak bonding, which reduces the degree of enhancement. The objectives of this study were to fabricate aluminum-based metal matrix composites with enhanced wettability at varying stirring speeds (350, 450, 550 rpm), stirring time (5, 10, 15 min), weight percentage of SiC (0, 5, 10 wt.%), and weight percentage of MoS₂ (0, 2, 4 wt.%). Nine samples were fabricated using stir casting based on Taguchi L9 orthogonal array. Hardness, tensile strength, and wear rate of the developed composite were investigated and analyzed as a single response characteristic using Taguchi's signal-to-noise ratio and as a multi-response characteristic using hybrid Taguchi-grey relational analysis (HTGRA). The results revealed that the addition of SiC in the composite produced better hardness, tensile strength, and wear rate. The addition of MoS₂ in the composite showed better hardness and tensile strength only up to 2 wt.% of MoS₂, and in the case of wear rate, the addition of MoS₂ in the composite up to 4% showed better wear resistance. Al-SiC-MoS₂ hybrid composite shows better enhancement in hardness, tensile strength, and wear resistance than the Al-SiC composite.