Related Experiment Video
Updated: Aug 29, 2025
Three-Dimensional Preoperative Virtual Planning in Derotational Proximal Femoral Osteotomy
Published on: February 17, 2023
The accuracy of component positioning during revision total hip arthroplasty using 3D optical computer-assisted
Alex Tang1,2, Vivek Singh1,3, Mohamad Sharan1
1Department of Orthopedic Surgery, NYU Langone Orthopedic Health, 301 East 17th Street, New York, NY, 10003, USA.
Introduction:
Despite the excellent outcomes associated with primary total hip arthroplasty (THA), implant failure and revision continue to burden the healthcare system. The use of computer-assisted navigation (CAN) offers the potential for more accurate placement of hip components during surgery. While intraoperative CAN systems have been shown to improve outcomes in primary THA, their use in the context of revision total hip arthroplasty (rTHA) has not been elucidated. We sought to investigate the validity of using CAN during rTHA.
Methods:
A retrospective analysis was performed at an academic medical institution identifying all patients who underwent rTHA using CAN from 2016-2019. Patients were 1:1 matched with patients undergoing rTHA without CAN (control) based on demographic data. Cup anteversion, inclination, change in leg length discrepancy (ΔLLD) and change in femoral offset between pre- and post-operative plain weight-bearing radiographic images were measured and compared between both groups. A safety target zone of 15-25° for anteversion and 30-50° for inclination was used as a reference for precision analysis of cup position.
Results:
Eighty-four patients were included: 42 CAN cases and 42 control cases. CAN cases displayed a lower ΔLLD (5.74 ± 7.0 mm vs 9.13 ± 7.9 mm, p = 0.04) and greater anteversion (23.4 ± 8.53° vs 19.76 ± 8.36°, p = 0.0468). There was no statistical difference between the proportion of CAN or control cases that fell within the target safe zone (40% vs 20.9%, p = 0.06). Femoral offset was similar in CAN and control cases (7.63 ± 5.84 mm vs 7.14 ± 4.8 mm, p = 0.68).
Conclusion:
Our findings suggest that the use of CAN may improve accuracy in cup placement compared to conventional methodology, but our numbers are underpowered to show a statistical difference. However, with a ΔLLD of ~ 3.4 mm, CAN may be useful in facilitating the successful restoration of pre-operative leg length following rTHA. Therefore, CAN may be a helpful tool for orthopedic surgeons to assist in cup placement and LLD during complex revision cases.
