Related Experiment Video
Updated: Aug 26, 2025

Oscillation and Reaction Board Techniques for Estimating Inertial Properties of a Below-knee Prosthesis
Published on: May 8, 2014
Characteristics of hip joint reaction forces during a range of activities
Robin Layton1, Neil Messenger2, Todd Stewart1
1Institute of Medical and Biological Engineering, Faculty of Engineering and Physical Sciences, The University of Leeds, Leeds LS2 9JT, United Kingdom.
Abstract:
The paper reports the characteristics of joint forces for 9 activities in 18 normal healthy subjects. Activities included Walk, Walk Turn, Stand to Sit, Sit to Stand, Squat, Stand Reach, Kneel Reach, Lunge, and Golf Swing. Within the cohort ∼30% variability occurred in the manner in which each activity was completed. Within the activities the average maximum load characteristics varied in magnitude (0.5-6.4 ρBWT) and also in duration (0.96-5.89 s.) when compared to walking (3.1 ρBWT,1.1 s.). The corresponding impulse ranged from 1.6 during the Walk to 6.7 ρ.BWT.s for the Golf Swing . As high loads with low sliding velocities have been shown in the literature to be damaging to the tribology of compliant contact surfaces the findings are postulated by the authors to be specifically important for the pre-clinical testing of cartilage substitutional materials. Note: Force was normalized to body weight (ρBWT) throughout the study.
More Related Videos
Related Concept Videos
Support Reactions in Three Dimensions
Ball and Socket Joint is one of the supports allowing free rotation about any axis. This freedom of rotation is...
Method of Joints: Problem Solving II
Method of Joints: Problem Solving I
Support Reactions
The purpose of the supports is to prevent the translational motion of the system by applying an equal and opposite force and to prevent the system's rotation by applying...
Normal and Tangetial Components: Problem Solving
Bones of the Lower Limb: Femur and Patella

