Related Experiment Video

Updated: Aug 26, 2025

Electrochemically and Bioelectrochemically Induced Ammonium Recovery
09:50

Electrochemically and Bioelectrochemically Induced Ammonium Recovery

Published on: January 22, 2015

12.8K

Electrified Ion Exchange Enabled by Water Dissociation in Bipolar Membranes for Nitrogen Recovery from

Hang Dong1, Chloe Marie Laguna1, Matthew J Liu1

  • 1Department of Chemical Engineering, Stanford University, 443 Via Ortega, Room 387, Stanford, California94305, United States.

Environmental Science & Technology
|October 12, 2022
PubMed

Keywords:
ion exchange regenerationmembrane strippingresin conductivityresin regenerabilitywater splittingweak acid cation exchangers

More Related Videos

Ion-Exchange Membranes for the Fabrication of Reverse Electrodialysis Device07:55

Ion-Exchange Membranes for the Fabrication of Reverse Electrodialysis Device

Published on: July 20, 2021

10.8K
Generation and Control of Electrohydrodynamic Flows in Aqueous Electrolyte Solutions08:41

Generation and Control of Electrohydrodynamic Flows in Aqueous Electrolyte Solutions

Published on: September 7, 2018

9.0K

Related Concept Videos

Ion Exchange01:17

Ion Exchange

Ion exchange chromatography separates charged molecules from a solution by reversibly exchanging them with mobile, or 'active', ions associated with the oppositely charged stationary phase. This method can be used to separate ions, soften and deionize water, and purify solutions. The polymers comprising the ion-exchange column are high-molecular-weight and chemically stable polymers, crosslinked to be porous and essentially insoluble. They are also functionalized with either acidic or...
637
Dialysis01:15

Dialysis

Dialysis is a diffusion-based purification process that separates analyte molecules from a complex matrix. This is accomplished by allowing molecules in the solution to pass through a semipermeable membrane into a liquid on the other side. The membrane is usually made of cellulose acetate or cellulose nitrate, and the second liquid must be miscible with the solution. Ions (e.g., chloride or sodium) or organic molecules (e.g., glucose) can pass through the membrane pores, which generally have...
772
Potentiometry: Membrane Electrodes01:15

Potentiometry: Membrane Electrodes

Membrane electrodes, also known as p-ion electrodes, use membranes that selectively interact with free analyte ions, generating a potential difference across the membrane. The resulting membrane potential, known as the asymmetry potential, is not zero even when analyte concentrations on both sides of the membrane are equal. The membrane's response is typically not selective to a single analyte but proportional to the concentration of all ions in the sample solution capable of interacting at...
731
Pore Transport and Ion-Pair Transport01:17

Pore Transport and Ion-Pair Transport

Pore transport and ion-pair formation are critical mechanisms for the absorption and distribution of drugs in the body.
Pore transport, also known as convective transport, is a process where small molecules like urea, water, and sugars rapidly cross cell membranes as though there were channels or pores in the membrane. Although direct microscopic evidence is limited  but the concept of pores or channels is widely accepted based on physiological evidence. Despite the lack of direct...
586
Formation of Concentrated Urine01:23

Formation of Concentrated Urine

There is a gradient of solutes in the interstitial fluid from the renal cortex through the medulla, known as the medullary osmotic gradient. The juxtamedullary nephrons establish and maintain this gradient using countercurrent mechanisms with loops extending deep into the medulla. These nephrons also use countercurrent mechanisms to regulate urine volume and concentration. The interaction between the descending and ascending limbs of the nephron loop creates an osmotic gradient through...
2.0K
Electrodeposition01:08

Electrodeposition

Electrodeposition is a technique used to separate an analyte from interferents by electrochemical processes. Here, the analyte is a metal ion that can be deposited on an electrode immersed in the sample solution. The electrochemical setup consists of an anode and a cathode. When an electric current is applied to the setup, oxidation occurs at the anode. At the cathode, which consists of a large metal surface, metal ions undergo reduction and deposit onto the surface.
Electrodeposition can...
699