Kinematic adaptations to restricting spine motion during symmetrical lifting

When lifting an object from the ground a person has many possible whole-body movement solutions to accomplish the task. It is unclear why lifters use most of their available lumbar spine flexion range-of-motion despite many ergonomic guidelines advising against doing so. Experimentally restricting spine motion and observing compensatory movement strategies is one approach to address this knowledge gap. A kinematic analysis was performed on 16 participants who completed symmetrical lifting tasks with and without wearing a spine motion-restricting device. Sagittal trunk, lumbar spine, and lower extremity kinematics, along with stance width and foot orientation in the transverse plane were evaluated between restricted and unrestricted lifting conditions. Restricting spine motion required greater ankle dorsiflexion (p < 0.001), knee flexion (p < 0.001), and hip flexion (p < 0.001) motion in comparison to unrestricted lifting. Motion was reallocated such that hip flexion showed the largest increase in restricted lifting, followed by ankle dorsiflexion, then knee flexion compared to unrestricted lifting. Trunk inclination decreased (i.e., more upright) in restricted compared to unrestricted lifting (p < 0.001). Neither stance width (p = 0.163) nor foot orientation (p = 0.228) were affected by restricting spine motion. These adaptive movements observed indicate lower extremity joint motion must be available and controlled to minimize lumbar spine flexion during lifting.