Thermal effect on curved photovoltaic panels: Model validation and application in the Tabuk region

This paper aimed to investigate the temperature effect on photovoltaic (PV) cell parameters. The PV cell parameters such as series and parallel resistances, diode ideality factor, and diode saturation current, are not considered in the reported stepwise modeling. The present work aims to improve available models used in the modeling and simulation of PV modules to support the researcher and power project developer. All the required temperature-dependent parameters are determined to model the simulated PV module with high accuracy using Simulink/MATLAB software. To validate the method, a 36-cell-50W solar panel with different radii of curvature is set up to assess solar power outputs under varying irradiance and temperature conditions. For the present application, the Tabuk region (Saudi Arabia) is chosen based on its location and climatic conditions. The method provided conformity to the measured power outputs for varying Global Horizontal Irradiance (GHI) and temperature conditions. The maximum power output of the PV module increases from 14.4 W to 25.8 W when the received solar power density varies from 307 W/m2 to 526 W/m2 depending on the level of curvature starting from a semi-cylindrical shape to a vaulted shape to a flat shape. The curved PV module shows slightly higher power variation with temperature as compared to the flat one. Above 25°C, the power output is about 20% less at a maximum temperature of 65°C. When the temperature drops below 25°C, the power outputs increase about 6% and 11.5% for corresponding temperatures of 15°C and 5°C, respectively.