Influence of bending pre-load on the tensile response of the lumbar spine

Previous full body cadaver testing has shown that both obliquely oriented seats in survivable aircraft crashes and far-side oblique crashes in vehicles present distinctive occupant kinematics that are not yet well understood. Knowledge surrounding how these loading scenarios affect the lumbar spine is particularly lacking as there exists minimal research concerning oblique loading. The current study was created to evaluate a novel experimental method through comparison with existing literature, and to examine the impact of a static bending pre-load (posture) on the load-displacement response for the whole lumbar spine loaded in non-destructive axial distraction. T12-S1 lumbar spines were tested in tension to 4 mm of displacement while positioned in one of three pre-load postures. These postures were: the spine's natural, unloaded curvature (neutral), flexed forward (flexed), and combined flexion and lateral bending (oblique). Deviations from a neutral spine position were shown to significantly increase peak loads and tensile stiffness. The presence of a flexion pre-load caused statistically significant increases in tensile stiffness, tensile force, and bending moments. The addition of a lateral bending pre-load to an already flexed spine did not significantly alter the tensile response. However, the flexion moment response was significantly affected by the additional postural pre-load. This work indicates that the initial conditions of distraction loading significantly affect lumbar spine load response. Therefore, future testing that seeks to emulate crash dynamics of obliquely seated occupants must account for multi-axis loading.