[Determination of three penicillin residues in milk by solid-phase extraction-ultra performance liquid...

A method based on solid-phase extraction-ultra performance liquid chromatography-tandem mass spectrometry (SPE-UPLC-MS/MS) was established for the determination of gpenicillin, cloxacillin, ampicillin residues in milk. Using self-made covalent triazine frameworks (CTFs) as the solid-phase extraction sorbents, the main factors influencing the efficiency of the solid-phase extraction columns, such as the sorbent amount, eluent type, eluent volume, and flow rate, were optimized. The extraction and purification conditions for the samples were also investigated. The optimal extraction effect was achieved at a flow rate of 3 mL/min with 60 mg CTFs and 6 mL eluent solution (acetonitrile). Separation was carried out on a Waters ACQUITY UPLC BEH C18 column, and 0.1% formic acid aqueous solution-acetonitrile was used as the mobile phases for gradient elution. The filtrate was detected by ultra performance liquid chromatography-tandem mass spectrometry, identified by electrospray ionization (ESI) in the positive mode using multiple reaction monitoring, and quantified using external standards. The calibration curves of the three penicillins showed good linearity and the correlation coefficients of the linear regression equations for the three target analytes were all greater than 0.999. The limits of detection (LODs) and limits of quantification (LOQs) were 0.05-0.10 μg/kg and 0.1-0.4 μg/kg, respectively. The average recoveries of the three analytes were 84.9%-94.1%, and the relative standard deviations (RSDs, n=5) were 1.66%-3.27%. Moreover, the mechanism of interaction between the CTFs and the target analytes was analyzed. The results revealed the existence of π-π and hydrogen-bond interactions between the CTFs and analytes. The results further indicated that the CTFs could be successfully used for the enrichment and purification of penicillins in milk. The proposed method has the advantages of high precision, good reproducibility, high resolution, and short analysis time, and it is suitable for the qualitative and quantitative determination of trace targets in complex matrices.