Related Experiment Video

Updated: Aug 20, 2025

Morphology Control for Fully Printable Organic–Inorganic Bulk-heterojunction Solar Cells Based on a Ti-alkoxide and Semiconducting Polymer

Morphology Control for Fully Printable Organic–Inorganic Bulk-heterojunction Solar Cells Based on a Ti-alkoxide and Semiconducting Polymer

Published on: January 10, 2017

Impact of end-group modifications and planarity on BDP-based non-fullerene acceptors for high-performance organic

Muhammad Umar Saeed¹, N M A Hadia², Javed Iqbal^3,4

¹Department of Chemistry, University of Agriculture, Faisalabad, 38000, Pakistan.

Journal of Molecular Modeling

|November 23, 2022

Abstract:

With the aim to enhance the photovoltaic properties of organic solar cells (OSCs), seven new non-fullerene acceptors (K1-K7) have been designed by end-group modifications of benzo[2,1-b:3,4-b']bis(4H-dithieno[3,2-b:2',3'-d]pyrrole) (BDP)-based small molecule "MH" (which is taken as our reference R) using computational techniques. To investigate their various optoelectronic parameters, DFT studies were applied using the B3LYP functional at 6-31G (d, p) basis set. The measurement of molecular planarity parameter (MPP) and span of deviation from plane (SDP) confirmed the planar geometries of these structures resulting in enhanced conjugation. Frontier molecular orbital (FMO) and density of states (DOS) analyses confirmed shorter band gaps of K1-K7 as compared to R, which promotes charge transfer in them. Optical properties demonstrated that these compounds have absorption range from 692 to 711 nm, quite better than the 684 nm of reference R. Molecular electrostatic potential (MEP) and Mulliken' charge distribution analysis also revealed the presence of epic charge separation in these structures. K1-K7 showed enhanced LHE values as compared to R putting emphasis on their better abilities to produce charge carrier by absorption of light. Reorganization energies showed that all newly designed compound could have better rate of charge carrier mobility (except K4) than R. Calculations of open-circuit voltage (V_oc) and fill factor (FF) revealed its highest values for K3 and K4. Among newly designed molecules, K3 showed betterment in all its investigated parameters, making it a strong candidate to get enhanced power conversion efficiencies of OSCs.

Keywords:

BDP-based small molecules Computational study Molecular planarity parameter Reorganization energies

More Related Videos

In situ Grazing Incidence Small Angle X-ray Scattering on Roll-To-Roll Coating of Organic Solar Cells with Laboratory X-ray Instrumentation

In situ Grazing Incidence Small Angle X-ray Scattering on Roll-To-Roll Coating of Organic Solar Cells with Laboratory X-ray Instrumentation

Published on: March 2, 2021

Printing Fabrication of Bulk Heterojunction Solar Cells and In Situ Morphology Characterization

Printing Fabrication of Bulk Heterojunction Solar Cells and In Situ Morphology Characterization

Published on: January 29, 2017

Related Concept Videos

π Molecular Orbitals of 1,3-Butadiene

π Molecular Orbitals of 1,3-Butadiene

Conjugated dienes have lower heats of hydrogenation than cumulated and isolated dienes, making them more stable. The enhanced stabilization of conjugated systems can be understood from their π molecular orbitals.
The simplest conjugated diene is 1,3-butadiene: a four-carbon system where each carbon is sp2-hybridized and has an unhybridized p orbital that contains an unpaired electron. According to molecular orbital theory, atomic orbitals combine to form molecular orbitals such that the number...

Stability of Conjugated Dienes

Stability of Conjugated Dienes

Introduction
A comparison of the enthalpies of hydrogenation of dienes reveals that conjugated dienes release less heat on hydrogenation, rendering them more stable than their nonconjugated analogs.

UV–Vis Spectroscopy: Woodward–Fieser Rules

UV–Vis Spectroscopy: Woodward–Fieser Rules

UV–Visible absorption spectra of conjugated dienes arise from the lowest energy π → π* transitions. The light-absorbing part of the molecule is called the chromophore, and the substituents directly attached to the chromophore are called auxochromes. A strong correlation exists between the absorption maxima, λmax, and the structure of a conjugated π system. The Woodward–Fieser rules predict the value of λmax for a given...

π Molecular Orbitals of the Allyl Cation and Anion

π Molecular Orbitals of the Allyl Cation and Anion

An allyl group is a three-carbon conjugated system where the sp³-hybridized allylic carbon is bonded to a CH=CH2 group via a single bond. Allyl anions can be obtained by treating propene with a strong base that can deprotonate methyl groups. Allyl cations are formed as intermediates during substitution reactions involving allylic halides. In both cases, the hybridization of the allylic carbon changes from sp3 to sp2, giving rise to a carbon chain with three sp2-hybridized carbons, each with...

Radicals: Electronic Structure and Geometry

Radicals: Electronic Structure and Geometry

This lesson delves into the geometry of a radical, which is influenced by the electronic structure of the molecule. The principle is similar to that of a lone pair, where the unpaired electron influences the geometry at the radical center.
Accordingly, the structure of a trivalent radical lies between the geometries of carbocations and carbanions. An sp2-hybridized carbocation is trigonal planar, while an sp3-hybridized carbanion is trigonal pyramidal. Here, the difference in geometry is...

Structure of Benzene: Molecular Orbital Model

Structure of Benzene: Molecular Orbital Model

According to the molecular orbital (MO) model, benzene has a planar structure with a regular hexagon of six sp2 hybridized carbons. As shown in Figure 1, each carbon is bonded to three other atoms with C–C–C and H–C–C bond angles of 120°. The C–H bond length is 109 pm, and the C–C bond length is 139 pm which is midway between the single bond length of sp3 hybridized carbons (154 pm) and sp2 hybridized carbons (133 pm).

Articles linked to this work by shared authors, journal, and citation graph.

Integrated in vivo and in silico validation of Corchorus olitorius seed-mediated cardioprotection against doxorubicin-induced cardiotoxicity via network pharmacology, molecular docking, and molecular dynamics.

Frontiers in chemistry·2026

Beyond PARP-HDAC inhibition: mechanistic rationale and medicinal chemistry insights from single to shared-target strategies.

Bioorganic chemistry·2026

Paeoniflorin Ameliorates Cecal Ligation and Puncture-Induced Acute Lung Injury in Mice by Modulating Oxidative Stress, Apoptosis, and Inflammation: Shedding Light on the Role of the JAK2/STAT3 Pathway.

Pharmaceuticals (Basel, Switzerland)·2026

Terminal acceptor engineering for reduced energy dissipation and enhanced charge transport in benzodithiophene-core based donor molecules: a computational route to efficient organic solar cells.

Nanoscale advances·2026

InhibitWin duo: Rational design and structural insights into dual PARP/HDAC inhibitors for synergistic DNA repair disruption and epigenetic modulation.

European journal of medicinal chemistry·2026

Network pharmacology reveals Ficus. Carica. L latex as a potential therapeutic agent for gastric ulcers by modulating inflammation and promoting repair.

PloS one·2025

See all related articles