Design and Preparation of Double-Harmonic Piezoelectric Composite Lamination

In this work, a new type of double-harmonic piezoelectric composite laminated structure is designed. Two bending vibration frequencies are generated by designing the structure with non-equal length and non-equal width, and the response is relatively consistent at the frequency point of the double-harmonic vibration. Firstly, the finite element software ANSYS is used to establish the simulation model of double-harmonic piezoelectric composite lamination. Two bending vibration frequencies are generated by using the non-equal length structure design, and the variation law of the conductance curve with the laminated structure is analyzed. Then, according to this law, the structure is optimized, and a non-equal width structure is further proposed in this work. Different double-harmonic piezoelectric composite laminations are prepared for comparison. The simulation and experimental results show that the value of the corresponding conductance curve at the two vibration frequency points can be increased or reduced by changing the lamination width. Then, the same conductance peak can be obtained to have a relatively consistent response at the double-harmonic frequency point. This will provide a good choice for expanding the transducer bandwidth and developing the broadband energy collector.