Study on the Elimination Method of Wind Field Influence in Retrieving a Sea Surface Current Field

An along-the-track interferometric synthetic aperture radar (ATI-SAR) system can estimate the radial velocity of a moving target on the ground and on a sea surface current. This acquires the interference phase by combining two composite SAR images obtained by two antennas spatially separated along the direction of movement of the platform. The key to retrieving the sea surface current is to remove the interference of sea surface waves, wind-generated current, and Bragg phase velocity in the interference Doppler velocity. Previous methods removed the surface waves, Bragg phase velocity, and other interferences based on externally-assisted wind fields (e.g., ECMWF), using the M4S or other models. However, the wind fields obtained from ECMWF and other external information are often average results of a large temporal and spatial scale, while the images obtained from SAR are high-resolution images of sea surface transients, which are quite different in time and space. This paper takes the SAR image data of the Gaofen-3 satellite as the research object and employs an SAR-based wind field retrieval method to obtain an SAR-observed transient wind field. Combined with the CDOP model, the interference of Doppler velocities, such as the sea surface wave, wind-generated current, and Bragg wave phase velocity, was calculated and subtracted from the Doppler velocity, to obtain the sea surface velocity result. Then, the current field measured by the shore-based HF radar was compared with that obtained by correcting the ATI Doppler velocity based on the SAR retrieved wind field and the ECMWF wind field. The comparison of results indicated that the wind field correction result based on the SAR retrieved wind field was closer to the current field measured by the shore-based HF radar than the wind field correction result based on the ECMWF wind field.